Filter
Top Products
Initial settings
29
switch the receiver off using the mains switch
on the unit
.
•
Set receiver 2 back into operation.
⇒
Press the
key and keep it pressed.
⇒
Using the numeric keys
... enter “
902
“.
•
To adopt the code switch receiver 2 into standby using the
key, and then
back into operation again. Set receiver 1 back into operation as well.
⇒
Press the
key and keep it pressed.
⇒
Using the numeric keys
... enter “
903
“.
Note
With the first two settings the remote control must be pointer towards the respec-
tive receiver which is switched on.
With the
key you can now switch between the two command sets A and B (tog-
gle function) and operate the two receivers in alternation.
On delivery command set 1 is always active.
Note
If you are using only one receiver and the active command set has been switched
over inadvertently due to maloperation rendering the receiver inoperable, the re-
mote control can be switched back to command set 1 without difficulty. The proce-
dure for this has already been described above.
Note
With remote control handsets that have 24 keys (remote controls of the 200-series
receivers from Kathrein) code numbers 001, 002 and 003 are to be entered in
place of codes 901, 902 and 903.