Connecting up and putting into operation
9
Tuning UHF channel / Checking operation
•
Switch on the satellite receiver via the on/off switch on the front of the unit. The
LED display on the unit shows the last programme slot that was selected.
•
Turn on your TV set.
•
Tune in an AV programme channel on your TV set if the satellite receiver and
TV set are connected by a Scart cable.
•
If the UHF connection is via a coax cable, tune in channel 38 to an empty pro-
gramme slot on the TV set (receiver‘s default channel).
Also take note of any instructions in the TV set‘s operating manual!
Note
If channel 38 is occupied by a terrestrially broadcast programme or the video re-
corder, adjust your TV set to a spare UHF channel in the range 21 to 69.
•
To avoid interference, when setting the UHF output channel try to ensure that
there is at least one free channel above and below the channel.
•
For tuning of UHF output channel at the satellite receiver refer to "Modulator" in
section: "Initial setting".
You can now receive the factory-preset TV and radio programmes. To find out how
to tune in additional TV and radio programmes, refer to sections: “Programming TV
programmes“ and “Programming radio programmes“.
External infrared sensor
If the receiver is to be operated from a location that cannot be reached using the
remote control handset, (with attachment of a further stereo system in another
room, for example), the URS 200 external infrared sensor can be connected up via
the data copy I/O connection (Western modular 8-way). You can then also control
the receiver from the other room.
Important All figures in this manual refer to the on-screen display in German. How to
select the OSD in English is described on page 24.