Filter
Top Products
First Time Installation
16
First Time Installation
The first steps
Connect the receiver to the mains power supply.
Switch on the receiver by pressing the power button on the front of the
unit.
The display, "- - - -,“ appears in the LED display.
When the LED for the operating display is red, the television is in
standby.
Switch on the receiver by pressing the
button on the remote
control.
The orange LED on the front panel of the receiver flashes each
time a button on the remote control is pressed.
You will see the factory set programme on your TV screen. An infor-
mation bar indicating the programme provider, the time, the timer set-
tings, the programme status and the programme title will be displayed
in the bottom section of the screen, provided the corresponding data
is transmitted. The number of the programme memory appears in the
LED display.
The red standby indicator goes out.
You can now receive the factory set TV and radio programmes and
call them up by pressing the
buttons. Press the
and buttons to select radio programmes. Press the
or button once more to return to TV programmes.
Refer to the section " Channel list –Radio/TV" for information on how
to set up and save other TV and radio programmes.
When the receiver is switched on, t he reception status, which
was last set, always reappears.
Please check the time of day for summer or winter.
If the message "bad or no signal" appears on the screen in addition to
an on-screen display indicating the programme last received, you will
need to check the system installation and/or the receiver settings. If
this problem only applies to individual programme slots, the problem
may be due to an interruption in the transmission signal or a fault in
the receiving system (cable or satellite system).
In this case, first check the connection configuration and then check
whether the basic settings of you receiver are correct for your system.
If necessary, have a specialist do this for you.
Factory setting of receiver
Your receiver is pre-programmed to receive the ASTRA and HotBird
satellites as well as Eutelsat 10E and 16E, TurkSat 42E, Telecom 5W
and 8W. You will normally not need to make further settings. If you are
not connected to a communal or party system, you need a multifeed
arrangement with at least two LNBs in front of the satellite dish, in or-
der to receive several satellite systems. Please ask your dealer.
Before you change the basic settings of your receiver, note down the
settings in the form provided at the end of this operating manual. You
will then be able to restore the original settings at any time.