Filter
Top Products
Setting System Parameters
58
Antenna settings
This menu is intended solely for service purposes and, if need be, i.e.
if no measuring instrument is available, it can be used to align the an-
tenna (satellite dish).
The satellite can be defined in the first line and the transponder in the
second.
The polarisation of the received signal and the transmitted symbol rate
are shown in the next line.
The bar displays provide an indication of the strength (relative level) of
the signal and its quality. However, no conclusions relating to the qual-
ity of the antenna system or of the cable connection can be derived
from this signal.
Antenna rotor / Positioner (DiSEqC 1.2)
For operation with a rotor (DiSEqC 1.2), select "on" in the line "Mo-
tor/Goto 0."
In the next line "Move/save", you can align the antenna to the west or
to the east using the
or button. Confirm the selection by press-
ing
. The optimal alignment can be observed by the bar diagram
"Level."
In the line "Set limiting value," you can direct the outer focuses (re-
stricted by walls and other hindrances) to west or east using the
or
button.
In each case, carefully read the operating manual from the rotor's
manufacturer (this especially includes other settings than those de-
scribed above).