Filter
Top Products
63
Transponder frequency
Use the
buttons (transponder frequency already saved) or the keypad (transponder frequency
not yet saved) to select the transponder frequency on which the channel being sought is transmitted.
At the bottom right of the screen display, the receiver shows the current signal strength and signal quality of
the selected transponder.
Press the
button to move to the next selection item.
The selection items: DVB type, FEC, polarisation and symbol rate need be input only if the
transponder has yet to be saved (see manual (channel) search).
Service ID
Using the
buttons or the keypad, enter here the service ID of the channel being sought.
When you have made your settings, use the
buttons to select “Start Search” and press the
button
to start scanning. You can cancel the scan at any time by pressing the
button.
During the scan you will see a display that shows you the progress of the scan.
After completion of the scan, you will see the following message (example):
Press the
button. You will be asked whether you wish to save the changes or not. Selection is performed
using the
buttons and is confi rmed using the
button. If you select “Yes, save changes”, the newly
found channels will be added to the end of the channel list. Then press the
button to exit the menu.
The channel list is called up on to the TV screen by pressing the
button (see also section “On-screen
displays” “Channel list TV/Radio”).
CHANNEL SEARCH (CHANNEL SCAN)