Filter
Top Products
10
|
KDV-415U/ KDV-MP5042U
Displayed item is depending on currently selected
source or mode. The mark in Condition column
shows the condition to which the item is displayed.
: Can be set in other than standby state.
: Can be set in standby state.
: Can be set only during playback of the iPod source.
(USB source used when the iPod is connected)
: Can be set during DVD source.
: Can be set during Tuner source.
: Can be set during FM reception.
: Can be set while accessing AV IN or AUX source.
: Can be set while HD Radio source.
: Can be set during Satellite radio source.
: Can be set for sources other than the standby
source by setting “2ZON” of <Audio Setup> (page
26) to “ON”.
— : Can be set during all sources.
⁄
• Refer to the respective page for information on how to
set the items with reference page number.
• Only the items available to the current source are
displayed.
• Strong electrical fields (such as from power lines) may
cause unstable sound quality when CRSC is turned ON.
In such a situation, turn it OFF.
* Factory setting
Function Control/ Setup Menu
Function Control
Functions in the table below can be set up by using Function Control.
1 Enter Function Control mode
Press the [
] button for at least 1 second.
“FUNCTION” is displayed.
2 Select your desired setup item
Operation type Operation
Movement between items Turn the [AUD] knob.
Selection of item Press the [AUD] knob.
Return to previous item
Press the [
] button.
Repeat selection and determination until your
desired setup item is selected.
In this manual, the above selection is indicated as
Press [ ] 1sec., and select “MENU” > “ICON”.
Category Function of setup item Condition
“iPodCTRL” Allows you to set up iPod Control by Hand
Mode.
“DSP” Allows you to set up the sound environment.
“MENU” Allows you to set up the environment. —
“RETURN” Exit Function Control mode. —
3 Make a setting
Press the [AUD] knob or turn the [AUD] knob to
select a setting value, and then press the [AUD]
knob.
• The value of items with [AUD] mark can be set by
pressing the [AUD] knob.
• The value of items with [4/ ¢] mark can be
set by pressing the [4] or [¢] button.
• Some items require you to keep pressing the
[AUD] knob for 1 or 2 seconds to set. For these
items, the time during which you need to keep
pressing the [AUD] knob is displayed in the Entry
column in seconds.
4 Exit Function Control mode
Press the [ ] button for at least 1 second.