Filter
Top Products
30
|
KDV-415U/ KDV-MP5042U
Audio Adjustments
Audio Preset Recall
Recalling the sound setup registered by <Audio
Preset Memory> (page 30).
1 Select the source
Press the [SRC] button.
2 Enter Audio Preset Recall mode
Press [ ] 1 sec., and select “DSP” > “PRESET”>
“RECALL”.
Press the [AUD] knob for at least 1 second.
• For how to select Function Control items, refer to
<Function Control> (page 10).
3 Select the number to recall in the memory
Turn the [AUD] knob to select number, and then
press the [AUD] knob.
“USER1” – “USER6”
4 Recall the Audio Preset
Turn the [AUD] knob to select “YES”, and then
press the [AUD] knob.
“COMPLETE” is displayed.
5 Exit Function Control mode
Press the [ ] button for at least 1 second.
⁄
• The User memory of <Preset Equalizer Select> (page 26)
is changed to the value which was recalled.
• The source tone memory item of <Preset Equalizer
Select> (page 26) is changed to the value which was
recalled by the selected source.
Audio Preset Memory
Registering the value setup by Sound Control.
1 Setup Sound Control
Refer to the following operations to setup the
Sound Control.
- Cabin selection (page 28)
- Speaker Setting (page 28)
- DTA (Digital Time Alignment) setting (page 29)
- X’Over setting (page 29)
- Preset Equalizer Select (page 26)
- Manual Equalizer Control (page 27)
- Position Control (page 27)
2 Enter Audio Preset Memory mode (Other than
Standby mode)
Press [ ] 1 sec., and select “DSP” > “PRESET” >
“MEMORY”.
Press the [AUD] knob for at least 1 second.
• For how to select Function Control items, refer to
<Function Control> (page 10).
3 Select the number to put in the memory
Turn the [AUD] knob to select number, and then
press the [AUD] knob.
“USER1” – “USER6”
4 Put the Audio Preset in the memory
Turn the [AUD] knob to select “YES”, and then
press the [AUD] knob.
“COMPLETE” is displayed.
5 Exit Function Control mode
Press the [ ] button for at least 1 second.
⁄
• Register 6 pairs of Audio Preset Memory.
• “USER1”: When you press the Reset, all the sources will
be the setting value which is registered.
• “USER1”, “USER2”:
The memory cannot be erased by the Reset button.
• This function cannot be registered when the iPod
Equalizer set in <Equalizer Control> (page 26).