Filter
Top Products
English
|
29
DTA (Digital Time Alignment) Setting
Adjusting fine tuning of the speaker position
compensation value specified at <Cabin selection>
(page 28).
1 Enter DTA setting mode
Press [ ] 1 sec., and select “DSP” > “SETUP” >
“DTA”.
Press the [AUD] knob.
• For how to select Function Control items, refer to
<Function Control> (page 10).
2 Select the speaker you want to set
Turn the [AUD] knob and push the center.
“FRONT” (Front speaker)/ “REAR” (Rear speaker)/
“SUB-W” (Subwoofer )
3 Set the compensation value of the speaker
position
Turn the [AUD] knob and push the center when
the desired value is displayed.
Adjust between 0 and 14.44 feet.
Refer to ✍ <Appendix> (page 34) on how to set
the compensation value.
4 Exit DTA setting mode
Press the [ ] button.
X’Over Setting
You can set a X’Over value for the speakers;
Setting item Range
Front High Pass Filter
“FRONT”
> “FC”
Rear High Pass Filter
“REAR” > “FC”
“THRU” (Through)/ 30/ 40 / 50/
60/ 70/ 80/ 90/ 100/ 120/ 150/
180/ 220/ 250 Hz
Front High Pass Slope
“FRONT”
> “SLOPE”
Rear High Pass Slope
“REAR” > “SLOPE”
-6/ -12/ -18/ -24 dB/Oct.
Subwoofer Low Pass Filter
“SUB-W”
> “FC”
30/ 40/ 50/ 60/ 70/ 80/ 90/ 100/
120/ 150/ 180/ 220/ 250 Hz/
“THRU” (Through)
Subwoofer Low Pass Slope
“SUB-W”
> “SLOPE”
-6/ -12/ -18/ -24 dB/Oct.
Subwoofer Phase
“SUB-W”
> “PHASE”
REVERSE (180°)/ NORMAL (0°)
1 Enter X’Over setting mode
Press [ ] 1 sec., and select “DSP” > “SETUP” >
“X’OVER”.
Press the [AUD] knob.
• For how to select Function Control items, refer to
<Function Control> (page 10).
2 Select the speaker you want to set
Turn the [AUD] knob and push the center.
“FRONT”/ “REAR”/ “SUB-W”
3 Select the item you want to set
Turn the [AUD] knob and push the center.
4 Set the X’Over value
Turn the [AUD] knob and push the center when
the desired value is displayed.
5 Exit X’Over setting mode
Press the [ ] button twice.