Filter
Top Products
9
3. Phantom power switch
This switch provides +48V power to devices such as condenser mics. This power is sup-
plied only to the XLR inputs. Turn this off if you're using dynamic mics or line input sources.
You can damage your equipment by connecting or disconnecting a condenser mic while the
phantom power switch is in the ON position. You must turn the phantom power switch OFF
before you connect a condenser mic.
4. DC 12V connector
Connect the included AC adaptor here.
5. USB connector
This lets you use a USB cable to connect the MR-1000 to your computer.
6. Balanced output jacks (XLR)
These are balanced outputs that allow XLR connectors to be used.
They output the same audio as the RCA jacks.
7. Unbalanced output jacks (RCA)
These are unbalanced outputs that allow RCA connectors to be used. They output the same
audio as the XLR jacks.
8. Input jacks (XLR/TRS combo)
These are balanced inputs that allow either XLR connectors or TRS phone connectors to be
used.
Unbalanced phone plugs can also be connected. Use the XLR jack for mic input, or the TRS
phone jack for line input.
If you're using phantom power with a condenser mic, you must use the XLR jacks.
2: HOT
1: GND
3: COLD
GND
COLD
HOT
GND
HOT
UnbalancedBalanced
TRS phone plug
TRS phone connector
XLR connector
2: HOT
1: GND
3: COLD
Text1_E.p65 06.11.22, 1:22 PM9