KVH Industries TracVision S2 Satellite TV System User Manual


 
Message Definition
KVH TracVision S2 Displays for 5 seconds at startup
Software Version Current software version
Alternates with “KVH TracVision S2”
Initializing System initializing
Search Mode 1 Antenna Unit in Search Mode 1
Search Mode 2 Antenna Unit in Search Mode 2
Search Mode 3 Antenna Unit in Search Mode 3
Reacquisition System is reacquiring the satellite
RF Signal Error RF signal detector has no signal at input
AZ Motor Error Fault detected in azimuth drive subassembly
EL Motor Error Fault detected in elevation drive subassembly
Differences among IRD low-speed data ports may result in
different message formats, and some messages may not be
displayed on the television screen. DIRECTV messages you may
see are listed in Table 2-4.
Message Definition
Searching for satellite – The IRD is powered up and
please stand by doesn’t detect the satellite signal.
Searching for program guide – The system has found the satellite,
please stand by but has been turned off for more
than approximately four hours. This
message appears for about
10 seconds.
Refer to your DIRECTV User’s Manual for specific messages
displayed by your system.
2-14
A Guide to TracVision S2
Table 2-4
DIRECTV On-screen Messages
Table 2-3
TracVision S2 Operational
Messages
The DISH Network and some
newer IRDs (e.g., the Sony A50)
give priority to internal IRD
messages rather than on-screen
messages. KVH recommends that
the maintenance port be used to
read installation-related messages
on a PC (see Section 2.5.2,
“Checking Out the System Without
an IRD Data Connection”).