Filter
Top Products
1
A Guide to TracVision S2 – ADDENDUM
54-0196 Addendum to Rev. A
TracVision S2 Owner’s
Manual Addendum
(ECO #6040)
The following information applies to Revision A of the
TracVision S2 Owner’s Manual (KVH Part Number 54-0196).
2 Installation
Kitpack Contents
Two plugs have been added to the kitpack for sealing the predrilled holes
in the antenna baseplate.
Part Qty. KVH Part No.
Switchplate assembly 1 02-1236-01
Tie-wraps 5 22-0013
RJ11 handset cable 1 32-0724-25
Clam shell ventilator 1 19-0230
#6 x
3
⁄
4" thread-forming screws 5 14-0298-12
1
⁄4"-20 x
5
⁄8" hex screws 4 14-0250-10
1
⁄4" flat washers 4 14-0251
3
⁄
8" hole plugs 2 19-0282-06
2.2 Mounting the Antenna Unit
A step has been added to the antenna mounting
procedure. The hole plugs need to be installed before
mounting the antenna unit to the vehicle.
6. Set aside the antenna unit and clean the roof’s
surface to remove any debris.
6b. Seal the two baseplate holes shown in Figure 2-4
with the plugs provided in the kitpack.
Table 2-2
Kitpack Contents
Baseplate Holes
Figure 2-4
Antenna Baseplate (Bottom View)