Filter
Top Products
3.2 Tracking the Correct Satellite
If your system is connected to an IRD’s low-speed data port,
follow the steps in Section 3.2.1, “Using the IRD for Satellite
Selection.” If your system is not connected to an IRD’s low-speed
data port, follow the steps in Section 3.2.2, “Using the Switchplate
for Satellite Selection.”
3.2.1 Using the IRD for Satellite Selection
If your TracVision S2 is connected to an IRD’s low-speed data
port, the antenna will automatically find and track the correct
satellite based on the information it receives from the IRD. No
user interaction is required.
3.2.2 Using the Switchplate for Satellite
Selection
If your system is not connected to an IRD’s low-speed data port,
you will need to use the switchplate to manually select the
satellite.
1. Press the switchplate’s SAT SELECT button.
2. The Status indicator flashes while the antenna
searches for a satellite signal. Once the antenna
finds and starts tracking a satellite, the Status
indicator stops flashing.
3. If your TV shows a clear picture, you are tracking
the correct satellite. If no picture appears, repeat
this procedure starting with Step 1.
3.2.2.1 The Status Indicator
If your system is not connected to an IRD’s low-speed data port,
the switchplate’s Status LED indicates the antenna’s current
condition. Table 3-1 describes this LED’s four conditions.
LED Condition Meaning
OFF Initializing, please wait
ON Tracking a satellite
Slow Flashing Searching for a satellite, please wait
Fast Flashing System error, see Section 4, “Troubleshooting”
3-3
Using Your TracVision S2
54-0196 Rev. A
Table 3-1
Status Indicator Conditions
If your antenna is unable to find the
desired satellite, refer to Section 4,
“Troubleshooting” for possible
causes and their corrective actions.