Filter
Top Products
BD-30 Blu-ray Disc Player
35
NTSC output via component:
1080p 60Hz* → 1080i 60Hz → 720p 60Hz → 480p → 480i
PAL output via component:
1080p 50Hz* → 1080i 50Hz → 720p 50Hz → 576p → 576i
* When 1080p is selected for the component output, HDMI output
resolution will be 1080p and component output resolution will be
1080i.
Note
• Some TV sets do not support one or more output resolutions
(particularly 1080p). If an incompatible output resolution is
selected, you will get a blank screen or an error message. In
this case please select an output resolution that is supported by
the TV.
• In case you are not able to get a picture using the HDMI or
component output, please connect the player to the TV using the
composite video output, then use the Setup Menu to adjust the
player settings.
• Video up-conversion over the component output is only available
for unencrypted discs such as home video and consumer-created
contents. Most commercially pressed DVD discs are CSS-encrypted
and will be limited to 480i/480p resolution. This restriction
applies to the component output only. The HDMI output is
protected with HDCP and has no such restriction.
Zooming and Aspect Ratio Control
This feature zooms in or out of
the displayed frame and also
changes the aspect ratio (image
width vs. height).
To change the zoom level, press
the ZOOM button on the remote
control. Each press of the ZOOM button will switch the zoom level
in sequence.
Zoom Levels for HDMI Output
The following zoom levels are available when “Primary Output” is
set to “HDMI”:
1:1 (No zooming) → Stretch/Letterbox/Pillar Box → Full Screen
→ Under Scan → 1.2 → 1.3 → 1.5 → 2.0 → ½ → Back to 1:1 again
The zoom level is reset to 1:1 when the disc is ejected, or when the
player is turned off.
The available zoom levels depend on the “TV Aspect Ratio”
setting in the Setup Menu and the aspect ratio of the DVD or
Blu-ray Disc. The following zoom levels may be useful for some
special applications:
1) Playing 16:9 BD or DVD when “TV Aspect Ratio” is set to
“16:9 Wide” or “16:9 Wide/Auto”
• Stretch – The image is vertically stretched by 1.33 times. For
movies with 2.35:1 aspect ratio, this zoom level cuts off the
black borders at the top and bottom of the image. Users of
projector with anamorphic lens may find this mode helpful.
Original 2.35:1
Widescreen Movie “Stretch” Zoom
Projected through an Anamorphic Lens
ZOOM