Filter
Top Products
BD-30 Blu-ray Disc Player
75
No color Video system is not supported by the TV When playback is completely stopped, press the P/N button or set
the correct TV System in the Setup Menu.
35, 54
Saturation set too low Check the saturation setting on TV and player. 58
Loose or damaged component video cables If using component output, check that the three cables are all
properly plugged in and not damaged. Make sure the color of the
plugs match the jacks on both ends.
15
Incorrect video output port If using composite video output, check that the cable is not
incorrectly plugged into a component video jack.
13
Incorrect color Incorrect color space setting If using HDMI for video output, check the color space setting on
the TV and player.
53
Incorrect component video cable connection If using component video output, check the three component
video cables to make sure the signals match on both ends.
15
Picture rolling or split
picture
Video system is not supported by the TV When playback is completely stopped, press the P/N button or set
the correct TV System in the Setup Menu.
35, 54
“No Disc” or
“Unknown Disc” error
No disc or incompatible disc loaded in player Eject disc and check. 28
Dirty disc recording surface Eject the disc and clean any dirt or fingerprints. 4
Disc not properly loaded Eject disc and make sure the label side is facing up and the record
side is facing down.
28
Condensation on the Laser pick-up head Turn on the player, eject the disc and leave the player on for about
an hour.
3
Remote control failure Remote control is out of range Use the remote control within the effective range. 11
Low battery Replace the batteries. 11
Incorrect remote control code Make sure that no disc is playing. Aim the remote at the player;
press and hold the ENTER button on the remote for 5 seconds to
set the remote code.
12
Temporary function
failure
Scratched or damaged disc is used Replace the disc. 28
Some functions are not available during playback Stop playback completely, then try again. 28
Interference from other devices Identify interference by turning off other devices, and then
relocate or replace the offending device.
3
Some Setup Menu
items are grayed out
Some setup options cannot be changed while a disc is
playing. Some setup options may be mutually exclusive with
other setup options.
Fully stop playback, eject the disc and try the Setup Menu again. 22
References