Filter
Top Products
MULTIPOINT RED/BLUE
T
he Multipoint Red/Blue Convergence controls enable you to adjust
the convergence at specific points on the TV screen.
NOTE: The onscreen display will leave the screen after 20 seconds of
inactivity. If this happens, simply press the MENU button to bring the
MANUAL CONVERGE submenu back.
1
Press the MENU button. The menu appears. Press the
CURSOR BUTTON RIGHT to enter the PICTURE menu.
Then press the CURSOR BUTTON DOWN until
MANUAL CONVERGE is highlighted.
2
Press the CURSOR BUTTON RIGHT to enter
the MANUAL CONVERGE submenu. Press the
CURSOR BUTTON DOWN until MULTIPOINT RED
or MULTIPOINT BLUE is highlighted. Then press
the CURSOR BUTTON LEFT or RIGHT to enter
Navigate mode.
3
Press the CURSOR BUTTON LEFT, RIGHT, UP, or
DOWN to move to a cross hair that has a color outline.
Then press the EXIT/INFO button to enter adjust mode.
4
Press the CURSOR BUTTON LEFT, RIGHT, UP, or
DOWN to adjust the cross hair image until the color
outline is gone.Then press the EXIT button to return to
NAVIGATE mode. Repeat steps 3 and 4 until all mis-
aligned cross images have been adjusted.
5
After making your adjustments, you must store them in
the TV’s memory using SAVE MULTIPOINT.
NOTE: If you are not satisfied with the adjustments
you just made and want to start over, you can use the
UNDO MULTIPOINT control. This control allows you to
undo the adjustments, but it will work only if you use it
before saving.
To save your multipoint adjustments, press
the MENU button. This returns you to the
MANUAL CONVERGE menu. Press the CURSOR
BUTTON DOWN until SAVE MULTIPOINT is high-
lighted. Then press the CURSOR BUTTON LEFT or
RIGHT to store your adjustments in the TV’s memory.
OR
To undo the multipoint adjustments you just made,
press the MENU button. This returns you to the
MANUAL CONVERGE menu. Press the CURSOR
BUTTON DOWN until UNDO MULTIPOINT is high-
lighted. Press the CURSOR BUTTON LEFT or RIGHT to
undo the adjustments. Press the CURSOR BUTTON UP
until MULTIPOINT RED or MULTIPOINT BLUE is
highlighted. Press the CURSOR BUTTON LEFT or
RIGHT to enter Navigate mode. Then Follow steps 3–5
above to make your adjustments again.
OR
To restore the TV’s convergence to factory set-
tings, press the MENU button. This returns you to
the MANUAL CONVERGE menu. Press the CURSOR
BUTTON DOWN until RESTORE FACTORY is high-
lighted. Then press the CURSOR BUTTON LEFT or
RIGHT to restore the TV’s convergence to factory settings.
6
Press the EXIT/INFO button to exit the submenu.
ADJUSTING THE MANUAL CONVERGE CONTROLS
Adjusting the Manual Converge Controls
18
HELPFUL HINT
If you should experience a power outage
before saving your multipoint-convergence
settings, your settings will be lost.