Filter
Top Products
REMOTE CONTROL BUTTONS
Using the Remote Control
PIP
21 3
54 6
87 9
0
TV
SWAP PIP CH
DN
UP
FREEZE
SOUN
D
MUTE
SURF
A/CH
POWER
PICTURE
STATUS/
EXIT
POSITION
VCR
ACC
MENU/
SELECT
VOL
CH
TV/VCR
ACTIVE
CONTROL
6
Power . button – Press to turn the
TV ON and OFF.
FORMAT button – Press to toggle
the different screen format options.
AV (Source) button – Press
repeatedly to show the different AV
source.
Channel (+) or (–) buttons – Press
to access the next or previous
channel.
Cursor Buttons (Left x, Right
u, Up v, Downw) - Press
these buttons to highlight, select
and adjust items on the TV’s
onscreen menu. Also press the
Up or Down cursor to adjust
the picture format for 16:9 and
16:9 Zoom in digital mode. For
Analogue mode press Left and
Right cursor to adjust screen
format
OK button –
Press to activate
selection when programming
remote control.
A/D button –
Press to select
Analog or Digital mode.
Smart
Sound™ button – Press
to select an AutoSound™ control.
Choose from three factory-set
controls (VOICE, MUSIC, and
THEATRE) and a PERSONAL to
tailor the TV sound to enhance the
particular type of program you are
watching.
Number Buttons – Press to
select TV channels. When
selecting single-digit channels,
press the number of the desired
channel. The TV will pause for
a few seconds and then tune to
the selected channel.
Volume (+) or (–) – Press to
adjust the TV sound level.
MENU – Press to display the
onscreen menu. Press to return
to a higher menu level.
Exit/Info – Pressing the button
once shows the current channel
number, name (if set), time (if
set), and sound setting (stereo,
mono, SAP, or mute). Pressing
the button twice shows the
current AutoLock™ settings.
Pressing the button once when
an onscreen display is showing
removes the onscreen display.
SmartPicture™ – Press to
select a SmartPicture™ con-
trol. Choose from four fac-
tory-set controls—Movies,
Sports, Weak Signal,
and Multimedia—and a
PERSONAL control that you
set according to your own pref-
erences through the onscreen
Picture menu. (See page 31 in
the Directions for Use manual.)
The four factory-set controls
will enhance the TV picture
according to the particular type
of program you are watching.
It may also be used to enhance
pictures with weak signals.
A/CH – Press to alternate between
the currently viewed channel and
the previously viewed channel.
Mute – Press to turn the TV
sound off. To restore the sound to
its previous level, press the button
again.
Program Guide Button - In
digital mode, press to display
the current program infor-
mation. Press the ˙button to
access the program informa-
tion on the next time slot. The
quality and accuracy of the
infomation on the program
guide and the information
banner are transmitted from
the broadcasters. You may see
a difference in broadcast time
if the broadcaster is from a
different time zone area.
Note: AutoPicture™ is known as SmartPicture™ and AutoSound™ is known as SmartSound™ in this model.