7
OPERATING THE TELEVISION AND REMOTE CONTROL
Using the Remote Control
TV
SWAP PIP CH
DN
UP
FREEZE
SOUND
POWER
PICTURE
VCR
ACC
ACTIVE
CONTROL
USING THE TV BUTTONS
S
hould your remote control be lost or broken, you can still
change some of the basic picture and sound settings with the
buttons on the TV. Follow the steps below to familiarize yourself
with the functions of the TV buttons.
1
Press POWER/STANDBY to turn the TV on (or off).
Allow about 10 seconds for the TV to power on.
2
Press the VOLUME + or – buttons to decrease or
increase the sound level.
Press the VOLUME + and – buttons simultaneously to dis-
play the onscreen menu. After the menu appears, use these
buttons to enter submenus and make selections or adjust-
ments. (Use the CHANNEL buttons to move up and down
in the menu or submenus.) Press both VOLUME buttons
simultaneously to back out of the onscreen menus.
3
Press SOURCE SELECT to choose from among the sig-
nal inputs you have connected to the TV.
4
Press the CHANNEL buttons to select TV channels.
TELEVISION
REMOTE CONTROL
INSTALLING BATTERIES
T
o load batteries into the remote, follow these steps.
1
Gently press the tab on the battery cover on the back of
the remote and lift the battery cover off the remote.
2
Place the two “AA” size batteries in the remote’s battery
case. Ensure that the (+) and (–) ends of the batteries line
up correctly with the (+) and (–) inside the case.
3
Press the battery cover back into place.
Note: When operating the remote control, point the remote toward
the remote sensor window on the TV.
To prevent battery leakage that may result
in injury to you or damage to the remote
control:
• Install ALL batteries correctly, + and –,
as marked on the unit.
• Do not mix batteries (OLD and NEW or
CARBON and ALKALINE, etc.)
• Remove batteries when the remote con-
trol is not used for a long time.
Do not take apart, heat, or put batteries in
fire.
Remote Sensor
Window
BATTERY U SAGE CAUTION
• Be sure to point the remote toward the
sensor window on the TV.
• Be within about 30 feet (10 meters) of
the TV.
• Avoid dropping the remote on hard sur-
faces.
• Do not use harsh chemicals to clean the
remote. Use only a soft, lightly moist-
ened cloth.
H ELPFUL H INTS
Power Standby
Button
You can press any of the buttons on the front of the TV
to turn the TV on, but you must press thePower/Standby
button to turn the set off.
H ELPFUL H INT