Filter
Top Products
STANDBY-ON
TIMER SET
SLOW
VCR/TV
ZOOM
DISPLAY
3
456
789
SPEED
0
+10
2
1
VCRDVD
CLEAR
REPEAT
SETUP
TITLE RETURNMODE
C-RESET
A-B
AUDIO ANGLESUBTITLE
REC
REPEAT
DISC
MENU
OK
PAUSE
REW FF
PLAYSTOP
SKIP/
CH
SKIP/
CH
SEARCH MODE
34 One-Touch Recording
OTR (0:30)
SP
One-Touch Recording (OTR) lets you set a timed recording 30
minutes to eight hours long. Before you begin:
● Place the DVD/VCR in VCR mode. Press VCR so the green
VCR light appears on the front of the DVD/VCR.
● Select a recording speed (SP, SLP) with the SPEED button.
● Put a videotape in the cassette compartment. Make sure the
tape’s record tab is intact and the tape is long enough to record
the program(s).
1
Press VCR, then press SKIP i /CHo or SKIP j
/CHp or the Number buttons to select the channel
you want to record.
2
Press RECORD I on the front of the DVD/VCR
until the desired recording length (30 minutes to
eight hours) appears on the TV screen. Recording
will begin. The REC light and the TIMER REC light will
appear on the front of the DVD/VCR.
Stopping an OTR
To stop an OTR before recording is finished, press STOP on the
remote control or STOP/EJECT C A on the front of the
DVD/VCR.
To cancel the OTR but continue recording, press RECORD on
the front of the DVD/VCR repeatedly until REC appears in the
upper left corner of the screen.
When an OTR finishes, the DVD/VCR will either switch to DVD
model or turn itself off. If it changes to DVD mode, press
STANDBY-ON to turn it off.
After an OTR, the TIMER REC light flashes because the VCR is
still on standby for timer recordings. Press TIMER SET on the
remote or STOP/EJECT C A on the DVD/VCR to cancel timer
standby and use the VCR normally again.
• The remaining recording time will
appear on the display panel. Press
DISPLAY to see it on the TV screen.
• To change the recording length
while an OTR is in progress, press
RECORD
on the front of the
DVD/VCR
.
• You cannot start a timed OTR with
the REC
I
button on the remote.
• You cannot pause an OTR.
• If the preset time for a timer
recording comes up during an OTR,
the OTR has priority. The timer
recording will not take place.
• If the end of the tape is reached
during an OTR, the VCR will stop
recording, eject the tape, and
switch to DVD mode or turn off.
Helpful Hints
1
2
Press RECORD on the
DVD/VCR.