Magnavox ZC357MGX DVR User Manual


 
29EN 29EN
Recording Playback Editing
Introduction
Connections
Basic Setup
Function Setup Others
Español
SETTING THE CLOCK
Set the clock before you try the timer programming. If a PBS (public broadcasting station) is available in your area,
follow “Auto Clock Setting” below. If not, follow “Manual Clock Setting” on page 30.
Note
• The clock may set itself automatically after you
connect the antenna/cable signal and plug in the
power cord.
• Only the analog PBS channel signal is effective for
auto clock setting.
• The unit receives the clock data at 12:00 a.m. / p.m. from
the PBS channel when the unit is in the standby mode.
1
Press [SETUP] and use [K / L] to
select “General Setting”, then press
[OK].
“General Setting” menu will appear.
2
Use [K / L] to select “Clock”, then
press [OK].
“Clock” menu will appear.
3
Use [K / L] to select “Auto Clock
Setting”, then press [OK].
4
Use [K / L] to select “Auto”, then
press [OK].
Auto Clock Setting
OFF
Auto
Manual
5
Press [SETUP] to exit.
6
Press [STANDBY-ON yy] to turn the
unit to the standby mode.
This unit will search for the time only when the
power is in the standby mode. Leave it in
standby for several minutes to give this unit time
to set the clock.
Auto Clock Setting
This unit can set the time and date automatically by
referring to a PBS station.
Make sure
• The antenna/cable TV connections are correct.
• Channels are set. (Refer to page 26.)
• If this unit is connected to a cable/satellite box,
select the local PBS station on them to set the clock
automatically.
1
Select “Manual” at step 4, then press
[OK].
2
Use [the Number buttons] or [K / L]
to enter your PBS channel number,
then press [OK].
Set Channel No.
CH 1
3
Press [SETUP] and turn the unit to
the standby mode.
If the unit chooses an incorrect PBS channel, set the PBS
channel manually by following the steps below.
E7S50UD_ZC357MGX_v1.indd 29E7S50UD_ZC357MGX_v1.indd 29 2008/12/01 13:57:252008/12/01 13:57:25