Filter
Top Products
4Getting Started
17
English
Using the Setup Navigator
Before playing any discs, we strongly recommend using the
Setup Navigator. This makes all the basic DVD player settings for
you.
1 Press POWER button on the front panel to switch on.
Also turn on your TV and make sure that it is set to the correct video
input.
• The POWER button on the remote switches the player between
standby and on.
• If a disc that’s already loaded starts to play, press 7 to stop it.
Note
When it is required to remote control the power mode of this DVD
player, be sure to leave this switch in the power on mode.
2 Press SETUP.
The Setup Navigator on-screen display (OSD) appears:
General
A2
V2
Language
Audio1
Video1
Exit
Move
Select
Setup using the Setup Navigator
Setup Navigator
Setup Navigator
Start
Auto Start Off
SETUPENTER
Navigate all of the following OSDs using these controls:
Joystick up/down – cursor up/down
ENTER – select the highlighted menu option
Joystick left – go back to the previous question.
The control possibilities for the current OSD are shown at the bottom
of each screen.
3 Select ‘Start’.
General
A2
V2
Language
Audio1
Video1
Exit
Move
Select
Setup using the Setup Navigator
Setup Navigator
Setup Navigator
Start
Auto Start Off
SETUPENTER
Remember
Press ENTER to select an option.
• If you decide you don’t want to use the Setup Navigator, select Auto
Start Off here instead.