Filter
Top Products
Additional Information8
62
Picture playback stops and the operation buttons
cannot be used.
•
Press 7, then start playback again (3).
•
Switch the power off once using the front panel POWER
ON/OFF and then switch on again using the front panel
POWER ON/OFF.
New settings made in the Setup screen menus while
a disc is playing are ineffective.
• Some settings can be changed while a disc is playing, but
are not effective until the disc is stopped then restarted.
This is not a malfunction.
Make the same setting when the player is stopped.
Press 7, then restart playback (3). Note that making
settings in the Setup screen menus may cancel the
RESUME function.
Settings are canceled.
• When the power is cut due to power failure or by
unplugging the power cord, settings will be canceled.
Before unplugging the power cord, press POWER
button on the Remote Control and checking that
STANDBY indicator light on the front panel, then
press POWER ON/OFF the front panel to turn the
player off.
No picture/No color.
• Incorrect video connections.
Check that connections are correct and that plugs are
inserted fully.
• TV/monitor or AV amplifier settings are incorrect.
Check the instruction manual of the connected
equipment.
• The Component Video menu is set to Progressive but
your TV/monitor is not compatible with progressive scan.
Reconnect the player to your TV using a composite or
S-Video cord and set the TV to the appropriate input.
Now choose the Interlace setting in the Component
Video menu, then switch the TV input back to the
component input. (page 48).
Reset the player (page 65). Component Video will be
reset to Interlace but you’ll also loose other settings.
Check that VIDEO ON/OFF switch is set to the
correct position (page 51).
Screen is stretched or aspect does not change.
• The TV Screen setting in the Setup menu is incorrect.
Set the TV Screen option to match the TV/monitor
you're using (page 47).
Troubleshooting
Incorrect operation is often mistaken for trouble
or malfunction. If you think that there is something
wrong with this component, check the points
below. Sometimes the trouble may lie in another
component. Inspect the other components and
electrical appliances being used. If the trouble
cannot be rectified after checking the items below,
ask your nearest MARANTZ authorized service
center or your dealer to carry out repair work.
The disc is ejected automatically after loading.
• Dirty or damaged disc.
See page 58 for disc care information.
• Disc not seated properly in the disc guide.
Align the disc properly.
• Incompatible region number.
If the region number on a DVD-Video disc does not
match the number on the player, the disc cannot be
used (page 9).
• Condensation inside the player.
Allow time for condensation to evaporate. Avoid using
the player near an air-conditioning unit.
Playback is not possible.
• Disc is loaded upside down.
Reload the disc with the label side face up.
Cannot play DVD-RW disc
• If the display shows ‘COPY PROTECT PROGRAM,
UNPLAYABLE’, this means that this disc cannot be
played.
DVD-Audio playback stops.
• The disc may have been illegally copied.
mark appears on screen.
• The operation is prohibited by the player.
mark appears on screen.
• The selected function does not operate for that disc.
When making changes in the Setup OSD menus,
is displayed.
• There is a CD or Video CD loaded and the setting that
was changed applies only to DVD discs.
The settings will take effect next time a DVD is loaded.