Filter
Top Products
(i) SEN (SENSITIVITY)
Select the level of the pixel-based Motion
Sensing’s sensitivity level by channel or camera.
The sensitivity ranges from 1 to 99. The highest
sensitivity setting is 01, the lowest sensitivity
setting is 99. The default setting is 70.
(ii) MD-NUM (MOTION DETECTION NUMBER)
Sets the number of targets in which Motion
must occur in order to trigger an Alarm
(from 1-99 target areas).
Note: MD-NUM cannot be less than the
number of targets set in the AREA.
(iii) RE (REFERENCE)
Set the Reference image to which the
current screen is compared (from 1-99).
For example, the value 64 would compare to
the current image on the 64
th
previous screen
image.
(iv) DET (DETECTION)
The motion detection on each channel can
be turned ON or OFF individually.
(MENU)
TIMER
CAMERA
RECORD
ALARM
DWELL
PIP
MOTION
DISPLAY
REMOTE
USER
SYSTEM
EVENT
(MOTION)
SEN MD-NUM RE DET
CAM1 70 03 64 ON AREA
CAM2 70 03 64 OFF AREA
CAM3 70 03 64 ON AREA
CAM4 70 03 64 ON AREA
MOTION RECORD : ON
DAY START END
DAILY 00 : 00 00 : 00
-12-
(v) AREA
Press the ENTER button on this option to set the Pixel-based Motion Detection Area
for each channel. The Red target represents where the target is (Figure 1-1). The
Green target represents the Motion Detection Area (Figure 1-2), and Purple target
represents the motion currently taking place on screen (Figure 1-3). After motion stops
detecting, the color of the target will turn green (Figure 1-4).
To modify the Motion Detection Area, use the following controls
: turns the selected target ON/OFF.
▲▼◄►: navigates between targets
- : turns all targets on the screen ON/OFF
+ : turns all targets in the selected row ON/OFF
Note: When the “DET” (DETECTION) setting is “ON”, you must set the motion
detection AREA, or motion will not be triggered.
7. Motion
This section allows you to configure the DVR’s video motion
detection feature. This allows the DVR to record when changes are
detected in the camera’s field of view. This is a Pixel Based
Detection feature.