Filter
Top Products
Figure 1-1
MOTION DETECTION SETUP
1
2345678910111213141516
1
2
3
4
5
6
7
8
9
11
12
Figure 1-2
MOTION DETECTION SETTING — ROW SETUP
1
2 3 4 5 6 7 8 9 10 11 12 13 14 15 16
1
2
3
4
5
6
7
8
9
11
12
Figure 1-3
MOTION DETECTION TRIGGERED-TURNS
PURPLE
Figure 1-4
BACK TO MOTION DETECTION SETTING
1
2345678910111213141516
1
2
3
4
5
6
7
8
9
11
12
1
2345678910111213141516
1
2
3
4
5
6
7
8
9
11
12
-13-
(vi) MOTION RECORD
When the DET setting is “ON”, you can set up the MOTION RECORD function.
1. Select “ON” to enable the motion trigger recording: The system will automatically switch
to the Record Mode upon pixel-based motion detection. The motion detection will also
change the scanning sequence and show on the monitor.
For example: If the motion is detected on Camera #1, the recording & scanning
sequence will be more frequent on that channel. The sequence will be:
1st, 2nd, 1st, 3rd, 1st, 4th. Channel 1 will show on the screen. If
the 2
nd
and 3rd camera are both motion activated, they will be scanned
as 2nd, 3rd, 1st, 2nd, 3rd, 4th, 2nd, 3rd, 1st, 2nd, 3rd, 4th … and vice
versa. CH2 & CH3 will show for the same period of time that the
Alarm Duration time is set for.
NOTE: The trigger recording time will depend on the ALARM DURATION mode setting
(Please refer to page 10 for ALARM DURATION) and will record from the
last trigger time. For example, when the alarm duration setting is 1 min, the
recording time is from 9:00:00 to 9:01:00. If the motion detection is triggered
again at 9:00:40, the triggered recording time will be from 9:00:00 to 9:00:40
and 9:00:40 to 9:01:40. The total recording time is 00:01:40.