Filter
Top Products
12
CONNECTION-OUT (CONTINUED)
CONNECTING THE DVD TO A TV USING THE COMPONENT JACKS
PROGRESSIVE (YUV) VIDEO OUT:
Use these jacks to connect to a
TV with progressive video input jacks. Progressive scan is a video scanning system that
displays all lines in a frame in one pass, as opposed to the traditional system, interlaced scan.
This connection provides
optimum quality. To ensure maximum picture quality, use three video-grade cables for connections. Note that it is essential
to match the color-coded connectors with a compatible
TV. Press the I/P button on the remote to change between the
Progressive and Interlace modes.
525 LINE DIGITAL PROGRESSIVE-SCAN COMPONENT VIDEO OUTPUT
Compared to standard interlaced video, progressive scan ef
fectively doubles the amount of video information fed to your
TV
or monitor
.
The result is a stable, flicker-free image. (Check your
TV/monitor for compatibility with this feature.)
For the very highest picture quality
, try watching a movie on DVD-V
ideo on a progressive-scan compatible
TV
. While in the
Stop mode, press the I/P
button on the remote control to switch between Progressive Scan and Interlace Scan or change
the settings in the GENERAL
setup menu.
NOTE:
• CONSUMERS SHOULD NOTE THAT NOT ALL HIGH DEFINITION TELEVISION SETS ARE FULLY COMPATIBLE
WITH THIS PRODUCT
AND MAY CAUSE ARTIFACTS TO BE DISPLAYED IN THE PICTURE.
Audio Cable (Included)
Component Cable
(Not Included)
From
C
omponent
Video Out
F
rom
Audio
O
ut
T
o
Audio In
To
Component
V
ideo In
NOTES FOR CONNECTING TO A TV:
• If your TV has a Component input, connect the DVD recorder with the component cable for best results, otherwise use
the S-Video or Video OUT jack(s) on the DVD recorder.
• Set the TV’s TV/VIDEO button or switch to the VIDEO setting.
• When connecting the DVD, refer to the owner’s manual of the TV, as well as this manual.
• When connecting the DVD to the TV, make sure the power is off and both units are unplugged before making any
connections.
• Connect the DVD recorder to your TV directly. If you connect the DVD recorder through a VCR, the playback picture will
be distorted because DVD video discs are copy protected.
•
Connect a cable, etc. signal as described on the top of page 9 to use the tuner capabilities of this unit and one of the
OUT
video connections on the CONNECTION pages to play a disc.