Filter
Top Products
Four-Channel Digital Video Recorder
5
NOTE: You cannot use spot monitor output and VGA output at the same time.
NOTE: Set the CVBS or VGA selector switch before turning on the DVR. You cannot change
the setting while the unit is running.
Connecting the Monitor
Connecting the Spot Monitor
Figure 7 — Video Out connectors.
Connect the SPOT monitor to the Video Out connector.
NOTE: For SPOT monitor Output, set the CVBS/VGA selector switch to the CVBS.
Connecting the RGB Monitor
Figure 8 — VGA connector.
A VGA port is provided for RGB monitor output. Connect the RGB monitor to the VGA connector
if required. Connect an RGB cable with a DB-15 (male) connector, which is usually less than 10
feet, to the DVR connector.
NOTE: For RGB monitor output, set the CVBS/VGA selector switch to the VGA.
Connecting Alarms
Figure 9 — Alarm Input connector strips.
NOTE: To make connections on the Alarm Connector Strip, press and hold the button and
insert the wire in the hole below the button. After releasing the button, tug gently on the wire
to make certain it is connected. To disconnect a wire, press and hold the button above the
wire and pull out the wire.