Filter
Top Products
40
41
NetCommand
®
Initial Setup, continued
Review Screen
Figure 4
After you have made your device choices the Review
Screen will display. It is important to review the
settings to ensure that they are correct. If necessary,
you can use <Back to return to the Device Setup
screen to make changes.
Figure 4. Review screen
Finish Screen
Figure 5
To complete the NetCommand setup, select Finish
from the Finish screen.
If you wish to change any of the pre- configured
inputs or names for the devices, or add devices not
in the pre-configured setup, select Edit to display
Edit NetCommand menu.
If your A/V receiver was not listed, select Edit to
add the AVR and then assign all devices to new AVR
inputs.
It is still necessary to memorize the available
channels for Antenna-1 (and Antenna-2, if used).
You may do that by going to the TV Main menu
and selecting Antenna. Instructions to memorize
channels are found in the Antenna menu section.
Figure 5. Finish screen
Note: The Review screen lists the TV input and
A/V receiver input used with each device. You
must correctly identify the inputs you used when
you connected the devices. If you have not
connected your devices, write down these inputs
as a guide. If you cannot use these inputs, or if
you would like to change the name of a device,
use the instructions in Edit NetCommand to make
necessary changes.
Note: If you select Next> on the Review screen,
all selections made are finalized.
On the Review screen, adding or deleting check marks
will turn the adjacent devices, media cards or inputs
On or Off. 1394 device names only appear on the
Review screen when the devices are connected to the
TV.
Note: If TV Disc is not checked, TV Pause will
not be available.
Note: If you selected “Other” for any of
the device names, the TV can “Learn”
the connected device by following the Edit
NetCommand instructions. For many device
types, non-listed models will operate in the same
way as the listed models and you can still use the
pre-loaded setting.