Filter
Top Products
52
53
Device Selection Menu
Audio Section
When a NetCommand pre-memorized or learned IR
controlled A/V receiver has been connected to the TV
and added to NetCommand Setup, an AVR icon will
appear in the audio section. Press AUDIO to change
navigation to the audio section. Then press ADJUST
, , or to select the TV speakers icon or the
A/V receiver icon. Press ENTER to change the audio
selection. Press DEVICE to return the navigation to the
Device Section.
Power On/Off Devices
Devices that have separate On and Off remote control
buttons will power On automatically when you select
the device and will power Off when you turn off the TV.
For devices that do not power On or Off automatically,
display the Device Selection menu, press ADJUST
or to highlight the device icon and press POWER on
the remote control. For the A/V receiver, press AUDIO
to move the navigation to the Audio Section. Highlight
the A/V receiver icon and press POWER. If you
press POWER on the remote control when the Device
Selection menu is not displayed, the TV will turn Off.
Device Section
To select another device or input, press ADJUST
, , or on the TV’s remote to move the highlight.
Press ENTER to select the device to view and
hear. The TV inputs are automatically changed. If
NetCommand is set up, the inputs on compatible A/V
receivers are automatically changed at the same time.
Video Section
The destination of the device ighlighted in the Device
Section is displayed here as a TV icon.
Connection Section
The Connection Section shows the other devices
currently connected to the device highlighted in
the Device Section. For example, if the Digital VCR
(D-VCR) is currently recording, when you move the
highlight to the Ant-1 icon, the D-VCR icon will appear
in the Connection Section. This icon will disappear
when you move the highlight to another icon, press
CANCEL to stop recording.
When you press DEVICE on the TV’s remote control, the Device Selection menu (Figure 7) displays. If
NetCommand® has not been setup, the Device Selection menu allows you to select an input for viewing. If
NetCommand is setup, the Device Selection menu allows you to select the device for viewing, select audio from
the TV speakers or A/V receiver, power compatible devices On or Off, and verify the destination of signals. On the
Device Selection menu, the device or input currently displayed appears as a gold-colored icon.
If a device does not respond to separate On or
Off remote control signals, the manufacturer
has not provided that ability for the device.
IMPORTANT
Figure 7. Device Selection Menu with NetCommand
PIP Device Selection Menu
Figure 8
The PIP Selection menu displays when you press the
PIP DEVICE button on the remote control. This menu
has the same general format as the Device Selection
menu. The source for the Video Section is the sub
picture and the Audio and Connection Sections are not
available.
Use ADJUST , , or to move the highlight to
the device to show in the PIP or POP screen, then
press ENTER. Device icons that are grayed out are
not available for use as PIP/POP sources or with the
current source.
Video
Section
Connection
Section
Audio
Section
Device
Section
Figure 8. PIP Device Selection Menu
Video
Section
Device
Section