Mitsubishi Electronics WD-52526 Projection Television User Manual


 
68 Appendices
CAUTION
BURN DANGER!
During normal operation, the surfaces inside
the TV near the lamp are extremely hot.
TOUCH THE LAMP CARTRIDGE BY THE HANDLE ONLY
Do not touch the glass parts of the lamp cartridge.
CAUTION: If the television is on, press POWER to turn it off and unplug the AC power cord.
Allow the television to cool for at least one hour before attempting to replace the lamp car-
tridge.
LAMP LIFE
The light source for this television is a lamp, which is part of a lamp cartridge assembly. The actual life of the lamp
in this television can vary, based on the lamp itself, the air temperature around the TV while it is operating, and your
viewing patterns. Warmer air or poor ventilation shortens the lamp life, as does turning the television on and off fre-
quently.
When the end of the lamp’s average life is approaching, the TV displays a warning message for one minute when you
power on the TV. The message will reappear the next five times you turn on the TV. If you wish, you may continue
to use the current lamp until it stops working. After you change the lamp cartridge, you must reset the lamp
reminder through the TV Setup menu. Otherwise, the warning message will appear again earlier than necessary.
Mitsubishi warrants the lamp for one (1) year from date of the original purchase at retail. It is likely, however, that the
lamp will last significantly longer than this.
TO ORDER A NEW LAMP
To Receive a Replacement Lamp Under Warranty To Purchase a Replacement Lamp After Warranty
Call (800) 332-2119. Please have model number,
serial number, and TV purchase date available.
Call (800) 553-7278. Order lamp part number
915P028010.
WARNING
Do not remove the lamp cartridge immediately after turning off the television. You may get burned because of the
lamp’s high temperature. Allow the television to cool for one hour before attempting to replace the lamp cartridge.
Do not remove the lamp cartridge except when replacing it. Careless treatment can result in injury or fire.
Do not touch the lamp glass element. It may be very hot and break, causing injuries or burns.
Be sure not to insert any metal or flammable object into the lamp cartridge opening, as it may cause fire or electri-
cal shock. If a foreign object is inserted into the opening, unplug the AC cord of the TV and contact your dealer for
service.
Install the lamp cartridge securely. Failure to do so may cause a fire.
Do not touch the lamp glass elements. Oils from your fingers may cause premature lamp failure.
Hg
= MERCURY
THE LAMP INSIDE THIS PRODUCT CONTAINS MERCURY AND MUST BE RECYCLED OR
DISPOSED OF ACCORDING TO LOCAL, STATE OR FEDERAL LAWS. For disposal or recy-
cling information, please contact your local authorities or the Electronic Industries Alliance:
www.eiae.org
IMPORTANT
Reset the lamp hours through the TV setup menu each time you replace the lamp cartridge. Other-
wise, the lamp warning message will reappear sooner than necessary.
Appendix F: Lamp Cartridge Replacement