Mitsubishi Electronics WD-52526 Projection Television User Manual


 
72 Appendices
System Reset Button
If the TV does not respond to either the remote
control or the front panel controls or will not power
off, press the SYSTEM RESET button on the front
panel with a pointed item such as the point of a ball
point pen or end tip of a paperclip.
The TV will turn off and the green LED will flash
quickly for about one minute. When the green LED
stops flashing, you may turn on the TV again. The
changes you made while the TV was most recently
on, before you used the SYSTEM RESET button, may
be lost; the changes you made previously, however,
are not lost. Only those changes since the last power
on may be lost when the system reset button is
pressed. All other settings are retained.
TV Reset Menu
Select any device from the Device Selection menu.
Press TV MENU followed by 1,2,3 to open the RESET
SERVICE MENU.
Read on-screen warnings before pro-
ceeding, as some user data or settings
may be erased.
Select Reset System Defaults (CAUTION: All settings
except your V-Chip pass code will be reset to the
original factory defaults).
Service
If you are unable to correct a problem with your TV,
consult your Mitsubishi dealer or a Mitsubishi Authorized
Warranty Service Center.
DO NOT adjust any controls other than those
described in this Owner’s Guide.
DO NOT remove the protective back cover of your TV.
Menus not described and shown in this Owner’s Guide
are designed for factory use and for authorized service
personnel. Damage caused to the TV by unauthorized
changes or changes to these menus made by unauthor-
ized persons are not covered under warranty.
Support
To order replacement or additional remote controls,
lamp cartridges, or Owner’s Guides, call 800-553-
7278.
For questions, call Consumer Relations at 800-332-
2119.
E-mail: MDEAservice@mdea.com
Website: www.mitsubishi-tv.com
Appendix G: Troubleshooting, continued
Demo Mode
This TV has a demo mode for use in retail stores. To
turn off demo mode:
1. Press TV MENU.
2. When the menu appears, press the following
buttons in sequence:
0, QV, 0