Mitsubishi Electronics WD-62528 Projection Television User Manual


 
63
Chapter 5. TV Menu Screen Operations
After memorizing channels, the channels in memory
can be accessed in ascending or descending order by
pressing CH or . Select the Channel Menu to access
further channel-editing features such as channel add or
delete, channel name, and SQV custom favorite channel
memories.
When you use a CableCARD™, the complete list of
available channels is provided through the CableCARD.
As a result, the Ant-1 channel-memorization options are
not available and are shown grayed out on the screen.
In the TV Guide On Screen® system, the channels
displayed and the order in which they are displayed
are independent of the channel-memorization process.
Refer to the TV Guide On Screen Interactive Program
Guide User’s Manual for detailed instructions on editing
channels shown in this guide.
Clock
You may choose to manually or automatically set
the clock that your TV will use for recording or timer
functions.
Manual
Figure 9
To manually set the clock, you need to select the current
time, including AM or PM, current date, time zone for
your area and the Daylight Savings time setting.
Figure 9. Time Menu, Manual Clock Setting
Time
Press ADJUST or repeatedly to slowly select the
hour or press and hold to quickly select the hour. Press
ENTER to move to the minutes options. Press ADJUST
or to select minutes, then press ENTER to select AM
or PM.
Date
Press ADJUST or to select the correct date.
Setup Menu
Figure 8. Setup Menu
Setup Menu
Figure 8
Language
Display the on-screen menus in either English or Spanish
(Español). The first time you powered On your TV, you
were requested to select an on-screen menu language.
If you choose to change the selection, all menu text will
immediately switch to the language of your choice.
Program titles and other information sent by a
broadcaster will be shown in the original language.
Memorize Channels
For Antenna 1 (Main) or Antenna 2 (Aux)
To start channel memorization, first select an input
according to the table below.
Input Condition
Ant-1 Air
When connected to an indoor/outdoor
antenna
Ant-2 Air
Ant-1 Cable
When connected to direct cable
Ant-2 Cable
Press ENTER to start the automatic channel-memorization
process. The memorization process is started separately
for each antenna selection.
During the memorization process, all possible channels
on the selected antenna are scanned twice. Analog
channels are scanned first and then the process is
repeated for digital channels.
To stop the automatic channel-memorization process
before the process is completed, press CANCEL.
Channels memorized before you pressed CANCEL are
retained in memory. If you start the memorization process
again, all previously memorized channels for the selected
antenna input are erased and the process starts over from
the beginning.