Mitsubishi Electronics WS-55859 Projection Television User Manual


 
18
18
Part II: Installation
Connecting an Analog Antenna, Cable, or Cable Box
Connecting an Analog Antenna, Wall Outlet Cable, or Cable
Box
Separate UHF and VHF Antennas
(Figure 1)
1
Connect the UHF and VHF antenna
leads to the UHF/VHF combiner.
2
Push the combiner onto ANT-A on the
TV back panel.
UHF/VHF combiners are not provided
with the TV. They should be available at
most electronic stores.
Mitsubishi strongly recommends against using antennas with
twin at leads. Twi n at lead ant enna wir es are subj ect to
interference which may adversely affect the performance of the
TV. We recommend using coaxial antenna cable.
Cable Box
(Figure 3)
1
Connect the incoming cable to ANT-A on
the TV back panel.
Connect two coaxial cables as follows:
One from LOOP-OUT on the TV back panel to
2
IN on the cable box back panel.
3
One from OUT on the cable box back panel to
ANT-B on the TV back panel.
Figure 1. Connecting separate UHF and VHF antennas.
Figure 3. Connecting the cable box.
External
Antenna
or Cable
Back
Side
Flat Twin Lead
UHF Antenna
(Channels 14-69)
VHF Antenna
(Channels 2-13)
300 Ohm to
75 Ohm
Combiner
Flat Twin Lead
TV back panel
UHF
VHF
2
1
Antenna or Wall Outlet Cable for
Analog Broadcasts.
(Figure 2)
For antennas with twin at lead
1
For antenna with twin at leads, connect
the 300-Ohm twin leads to the trans-
former.
2
Push the 75-Ohm side of the transformer
onto ANT-A on the TV back panel.
300-Ohm to 75-Ohm matching trans-
formers are not provided with the TV.
They should be available at most elec-
tronic stores.
For cable or antenna with coaxial lead
3
Connect the incoming cable to ANT-A on
the TV back panel.
Mitsubishi strongly recommends against using antennas with
twin at leads. Twi n at lead ant enna wir es are subj ect to
interference which may adversely affect the performance of the
TV. We recommend using coaxial antenna cable.
1
2
300 Ohm Flat
Twin Lead
Optional 300 Ohm to 75 Ohm
Matchin
g
Transformer
75 Ohm
Coaxial Cable
TV back panel
p
1
2
3
Figure 2. Connecting antenna or wall outlet cable for
analog broadcasts.
1 2
3
4
5
6 7
8
9
10
11
12
OUT
Cable Box
back panel section
TV back panel
IN
Incoming
Cable
1
2
3