Mitsubishi Electronics WS-55859 Projection Television User Manual


 
67
67
Figure 1. Programming the remote to control your cable
box.
Figure 3. Programming the remote to control your VCR.
Figure 2. Programming the remote to control your satel-
lite receiver.
If you cannot turn the cable box ON
by pressing POWER, try pressing CHAN-
NEL or the number buttons.
When the switch is set to TV, the PLAY,
STOP, REW/REV, and FF/FWD buttons
will operate the VCR after the VCR codes
have been properly programmed into
the remote control.
Part IV: Operation
Programming the Remote Control to Control Non-NetCommand
A/V Products
To Program the Remote to Control
Other Brands of Audio and Video
Products:
(Figures 1-5)
1
Move the slide switch at the top of
the remote to the product you want to
control.
2
Press and hold the POWER button on
the remote control.
3
Enter the rst thr ee di gi t code li st ed for
your equipment, and then release the
POWER button on the remote control.
4
Point the remote control at the equip-
ment and press the POWER button.
If the equipment responds, the remote
control is properly programmed to oper-
ate the equipment. If the equipment
does not respond, repeat steps 2-4 with
the next three digit code listed in step 3
for your equipment.
Programming the Remote Control to Control Non-NetCommand™