Mitsubishi Electronics WS-55859 Projection Television User Manual


 
62
62
Part IV: Operation
Remote Control Functions: Channel Selection and Sleep Timer
Channel Selection
For Ant-A or Ant-B Channels:
Enter three numbers (for channel 2,
press 002).
or
Press the channel number and ENTER
(for channel 2, press 2, then ENTER).
or
Enter the channel number and wait four
seconds. The TV will change automati-
cally.
Sleep Timer
Setting the Sleep Timer:
Press SLEEP on the remote control.
A message indicating the length of time
the sleep timer is to be set for is dis-
played on the TV screen.
Each press of SLEEP will increase
the time displayed by 30 minutes, until
the maximum value of 120 minutes is
reached.
After 5 seconds of inactivity, the mes-
sage will disappear.
Press SLEEP to view the remaining time
before the timer turns the TV off.
Canceling the Sleep Timer:
Press SLEEP to display the on-screen
message.
Press SLEEP repeatedly until OFF is
displayed.
After 5 seconds of inactivity, the mes-
sage box will disappear.
Channel Selection, Sleep Timer, Operation of PIP and POP
For Ant-DTV Channels
(When Ant-DTV is the current device):
1
Enter two or three numbers for the
major channel number. If three num-
bers are pressed, the separator is
automatically added and you may pro-
ceed to step 2. If two numbers are
pressed, you must add the separator
by pressing the SUB button on the
remote control.
2
Enter a 1-digit sub-channel number
and wait four seconds. Enter a
1-digit sub-channel number and press
ENTER. Or enter 2 digits and the TV
will automatically switch channels.
Remote Control Functions: Operation of PIP and POP
Picture-In-Picture (PIP) and Picture-Outside-
Picture (POP) features allow you to view
Programming in different ways. While watch-
ing the main screen, you can display pro-
grams from other channels and other inputs.
You can display a single PIP, side-by-side
pictures, three POPs, or nine POPs.
Activating the PIP and POP
Figures 1-5 on following page
Press PIP/POP to activate the PIP/POP
option. With each press of the PIP/POP
button on the TV remote control (within 3
seconds of each other), the PIP/POP will
cycle through the following display options.
1
POP: side-by-side pictures
2
POP: three POPs
3
POP: nine POPs
4
PIP: PIP
5
PIP/POP: off
To turn PIP/POP off, wait at least 10 sec-
onds, and press PIP/POP. The next time
you activate PIP/POP, the last used PIP/
POP option will be displayed rst .