Filter
Top Products
22
Connecting the DV-CP706
—Continued
Notes:
• The DV-CP706 supports HDCP (High-bandwidth
Digital Content Protection), a protection system for
digital video. HDMI components that you connect to
the DV-CP706 must also support HDCP.
• The DV-CP706 supports HDMI (High-Definition
Multimedia Interface) Specification Information Ver-
sion 1.0.
HDMI & the DV-CP706
■
Video
The DV-CP706’s HDMI OUT supports the following
video resolutions:
• 720 x 480i 60 Hz
• 720 x 480p 60 Hz
• 720 x 576i 50 Hz (Australian model only)
• 720 x 576p 50 Hz (Australian model only)
• 1280 x 720p 50/60 Hz
• 1920 x 1080i 50/60 Hz
• 1920 x 1080p 50/60 Hz
If the connected HDTV or projector doesn’t support a
resolution, you may get no picture.
On the DV-CP706, you can select a resolution suitable
for use with the connected HDTV or projector (see
page 24).
■
Audio Formats
The DV-CP706’s HDMI OUT supports the following
audio formats:
• PCM (48 kHz, 44.1 kHz, 96kHz)
• Dolby Digital
• DTS
If your TV only supports HDMI digital audio up to
48 kHz, change the Linear PCM Out setting to Down
Sample On (see page 46).
If your TV doesn’t support Dolby Digital, set the Digital/
HDMI Audio Out setting to PCM (see page 46).
If your TV doesn’t support DTS, the DV-CP706 will not
be able to play DTS format audio or soundtracks. In this
case, on your DVD-Video disc’s audio setup menu,
select an audio format other than DTS.
RIHD (CEC)
The DV-CP706 supports RIHD (Remote Interactive over
HDMI), which is Onkyo’s implementation of CEC
(Consumer Electronics Control), which allows inte-
grated system control over HDMI and is part of the
HDMI standard. In addition to Onkyo AV components, it
allows interoperability with CEC-compatible AV com-
ponents and TVs made by other manufacturers.
To use RIHD, make sure that CEC is turned on on your
other components (e.g., TV, AV receiver)
• The remote controller supplied with Onkyo AV
receiver or amplifiers can be used to control the
DV-CP706.
• The function of the upper and lower connectors are
the same. Connect to either one.
• Connecting an cable only does not make the sys-
tem operational. You must also connect the audio
cables as well.
•For remote control operation, you must make an ana-
log RCA connection between your DV-CP706 and the
other AV component, even if they are connected digi-
tally.
• If you’re using RIHD, do not connect anything to the
RI connectors.
Connecting -compatible
Components
L
R
ANALOG
AUDIO
OUTPUT
REMOTE
CONTROL
AV receiver
L
R
IN