Filter
Top Products
15
Front & Rear Panels
—Continued
A
AUDIO OUTPUT [20, 22, 23]
These jacks make up the multichannel analog audio
output. The FRONT/D.MIX jacks can be connected
to a stereo input on a TV, hi-fi amp, or other compo-
nent. The 1 and 2 jacks output the same signals, so
use either pair. If you use this connection, in the
Speaker Configuration (page 48), set the Sub-
woofer, Center Speaker, and Surround Speaker set-
tings to Off, so that 5.1-channel DVD audio is down
mixed into two channels.
If you’re using an AV receiver or surround decoder
with a 5.1-channel analog audio input, use the
FRONT/D.MIX 1 or 2 jacks and the SURR 1 L/R,
CENTER, and SUBWOOFER jacks.
If you’re using an AV receiver or surround decoder
with a 7.1-channel analog audio input, connect the
SURR 2 L/R jacks to your amp’s surround back L/R
jacks, and set the SURR MODE switch to “1+2.”
The SURR 1 and SURR 2 jacks output the same
signals.
B
jack [23]
These (Remote Interactive) connectors can be
connected to the connectors on your other
Onkyo AV components for interactive control.
Connecting an cable only does not make the
system operational. You must also connect the audio
cables as well.
C
RS 232 (North American model only)
This port is for servicing.
D
IR IN/OUT (North American model only) [25]
A commercially available IR receiver can be con-
nected to the IR IN jack, allowing you to control the
DVD player when it's out of sight, for example,
installed in a cabinet.
A commercially available IR emitter can be con-
nected to the IR OUT jack to pass IR (infrared)
remote control signals along to other components.
E
S VIDEO OUTPUT [21]
This connector can be used to connect a TV or pro-
jector with an S-Video input.
F
VIDEO OUTPUT [20]
This RCA connector can be used to connect a TV or
projector with a composite video input.
G
COMPONENT VIDEO OUTPUT [21]
These jacks output component video and can be
connected to an component video input on a TV or
projector.
H
OPTICAL DIGITAL AUDIO OUTPUT [22]
This optical digital audio output can be connected to
an optical digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS).
I
COAXIAL DIGITAL AUDIO OUTPUT [22]
This coaxial digital audio output can be connected
to a coaxial digital audio input on a hi-fi amp, AV
receiver, or surround sound decoder (Dolby Digital,
DTS) with supplied coaxial cable.
J
AC INLET [26]
The supplied power cord is connected here. The
other of the power cord should be connected to a
suitable wall outlet.
K
SURR MODE switch [23]
This switch is used to turn the AUDIO OUTPUT
SURR 2 on or off. To use this output, set the switch
to “1+2.” The SURR 2 jacks output the same signals
as the SURR 1 jacks.
L
HDMI OUT [24]
This HDMI output can be used to connect a TV or
projector with an HDMI input. This HDMI connec-
tor outputs digital audio and digital video.
M
AV CONNECTOR (European model only) [21]
This SCART output can be connected to a TV or
projector with a SCART input. This SCART con-
nector outputs 2-channel stereo audio (same signals
as the FRONT/D.MIX jacks), composite video,
S-Video, and RGB video.