39
EN
OPERATING TV
OPERATING DVD
SETTING DVD
INTRODUCTION PREPARATION SETTING TV
TROUBLESHOOTING
ESPAÑOLINFORMATION
Stereo Sound Mode
CD
This unit allows you to select a sound mode during CD playback.
1
Press [AUDIO] repeatedly until the desired sound
mode appears.
STEREO
• Each time you press [AUDIO], the audio language
changes as example below.
STEREO (Right and left channels are active.)
L-ch (Left channel is active.)
R-ch (Right channel is active.)
NOTE:
• Virtual Surround cannot be changed when the sound mode is
set to either L-ch or R-ch.
-
Virtual Surround
DVD CD MP3
You can enjoy virtual surround sound on your existing 2 channel stereo
system.
1
During playback, press [MODE] repeatedly until the
“ “ appears.
OFF
2
Press [ENTER] to select the sound level.
1
1 : Natural effect.
2 : Emphasized effect.
OFF : No effects (original sound).
3
To exit the Virtual Surround setting,
press [BACK/RETURN].
NOTE:
• The setting will be kept even if the unit is turned off.
• On Audio CDs, Virtual Surround will not be effective if the
sound mode is set to something other than “STEREO”.
Refer to “Stereo Sound Mode”.
• Turn down the level or select “OFF” if the sound is distorted.
Marker Setup
DVD CD
This feature allows you to assign a speci c point on a disc to be called back
later.
To set a marker
1
During playback, press [SEARCH MODE] repeatedly
until the “ “ appears.
2
Use [s / B] to select a desired marker within 30 sec-
onds.
or
3
Press [ENTER] to set the marker.
4
To exit the Marker setup display,
press [BACK/RETURN].
To return to the marker later
1
In stop mode, press [SEARCH MODE] repeatedly until
the “ “ appears.
2
Use [s / B] to select a desired marker within 30 sec-
onds.
or
3
Press [ENTER] at the desired marker to restart playback
from the specific point which you set.
NOTE:
• The Marker display will disappear in about 30 seconds when
there is no input.
• You can mark up to 10 points.
• To clear a marker, select the marker to be cleared at step 2 in
the section “To set a marker” or “To return to the marker later”,
and then press [CLEAR].
• Ejecting the disc or turning off the power will erase all markers.
• Selecting “
” at step 2 in the section “To set a marker” or “To
return to the marker later” will also erase all markers.
L4360UA.indd 39L4360UA.indd 39 2006/11/21 15:41:512006/11/21 15:41:51