Filter
Top Products
106 EN106 EN
TROUBLESHOOTING
CHANNEL
TV channels cannot be changed. • Check if the connections are made securely and correctly.
• Check if the cables are damaged.
• Try channel setting by following the steps on pages 28 to 31.
Only specific channels do not appear. • The channels may be set to be skipped. (Refer to pages 29-30.)
The external input channels (such as
L1, L2 or L3) cannot be skipped.
• This unit does not skip the external input channels. This is not a
malfunction.
RECORDING
GENERAL
The image from the external device
cannot be displayed.
• Try pressing [INPUT SELECT] repeatedly.
• Turn on all connected devices.
• Check if the connections are made securely and correctly.
Some part of the recorded content
has no image and sound.
• When you record the copy-protected programs, part of the recorded
content may has no image and sound.
HDD / DVD
Recording is impossible. • It is prohibited to make a recording from 2 minutes before the
programmed start time of a timer recording.
• This unit cannot record programs that contain copy protection signal.
This is not a malfunction.
• The space of the recording media may be used up. Try deleting
unnecessary titles, or exchange it with the recordable media.
• The maximum number of titles or chapters has exceeded. Delete the
unnecessary titles to make enough space or insert a new recordable media.
• Check if the connections are made securely and correctly.
• Check the external input channel.
Timer recording cannot be
performed.
• The internal clock of the unit may have been stopped due to a power
failure that lasted for more than 30 seconds. Reset the clock. (Refer to
pages 31 to 32.)
HDD
The picture of the autostart
recording disappears.
• The contents of the autostart recording will be cleared in some cases
(Changing input channel etc.). Refer to page 48.
When playing back the title
recorded from the autostart
recording, the DTV program
information is displayed and it
cannot be disappeared.
• In the autostart recording, when you display the DTV program
information, the information will be recorded as the part of the picture.
DVD
“Repairing” appears on the TV
screen.
Repairing
• If there is a power failure or unplugging during recording, finalizing,
formatting or editing (even after “Repairing” disappears), a repairing
process will begin automatically just after turning the unit on again.
It may take several minutes up to about several hours.
In a case you intend to cancel the
repairing process.
Repairing
Do you want to cancel a repairing
process? When selecting “Yes”,
the disc may not be usable.
Yes
No
• If you intend to cancel the repairing process, press [A OPEN/CLOSE]
on the front panel, then select “Yes” and press [ENTER]. After that, press
[OPEN/CLOSE A] to take out the disc. The disc canceled during the
repairing process MAY NOT work.
Recording is impossible. • Check if the disc is protected or nalized. Undo the protection or the
nalization.
• Video mode DVD-RW once formatted on other unit cannot be recorded
on this unit unless all the contents in the disc are erased.
• Check if the connections are made securely and correctly.
The indication
“
Writing to Disc 100%
”
does not disappear.
• “
Writing to Disc 100%
” may remain on screen for the
maximum of 20 seconds even after it reached 100%. This is not a
malfunction.
E2M20UD_H2160SL9_EN.indd 106E2M20UD_H2160SL9_EN.indd 106 2008/02/20 15:34:172008/02/20 15:34:17