Filter
Top Products
Use the clamper when
connecting a LAN cable.
(see page 58)
These accessories will be used by professional installers when
they install the unit.
TH-85VX200U
TH-103VX200U
Accessories
Requires two AA batteries.
2. Insert batteries - note correct
polarity (+ and -).
Precaution on battery use
Incorrect installation can cause battery leakage and corrosion that will damage the remote control transmitter.
Disposal of batteries should be in an environment-friendly manner.
Observe the following precautions:
1. Batteries should always be replaced as a pair. Always use new batteries when replacing the old set.
2. Do not combine a used battery with a new one.
3. Do not mix battery types (example: “Zinc Carbon” with “Alkaline”).
4. Do not attempt to charge, short-circuit, disassemble, heat or burn used batteries.
5. Battery replacement is necessary when the remote control acts sporadically or stops operating the Plasma Display.
6. Do not burn or breakup batteries.
Batteries must not be exposed to excessive heat such as sunshine, fi re or the like.
Accessories Supplied
Remote Control
Transmitter
N2QAYB000562
3D Eyewear set
(see page 23)
Screwdriver
Operating Instructions
Remote Control Batteries
Check that you have the Accessories and items shown
Helpful Hint:
For frequent remote control users, replace old batteries with Alkaline batteries for longer life.
1. Pull and hold the hook, then
open the battery cover.
Open
Close
Hook
“AA” size
Batteries for
the Remote
Control
Transmitter
(AA Size × 2)
Fixing band × 2
TMME203
Eyebolt cap × 1
Eyebolt cap × 1 Eyebolt × 1
(M16)
Allen wrench
Eyebolt × 1
(M12)
Allen wrench
Clamper × 1
TMM15412-2
AC cord
TH-85VX200U TH-103VX200U
For 3D Eyewear
(see page 24)
10