Panasonic 103VX200U Flat Panel Television User Manual


 
Using Network Function
This unit has a network function to control the network connected display with your computer.
Note:
To use the network function, set each “NETWORK SETUP” setting and make sure to set the “CONTROL I/F SELECT”
to “LAN”. (see page 55)
When “LAN” is set, power is supplied to LAN circuit, and power indicator is lit orange under the condition of power off
with remote control (stand-by state).
Example of Network Connection
Command Control
Network function of the unit can control the unit in the same way as serial control from a network.
Supported commands
Commands used in the serial control are supported. (see page 16)
Note:
Consult your local Panasonic dealer for detail instructions on command usage.
Hub or broadband router
LAN cable
(not supplied)
Notes:
• Lay the LAN cable away from other connection cables (excluding the power cord).
• Make sure the broadband router or hub supports 10BASE-T/100BASE-TX.
• To connect a device using 100BASE-TX, use “category 5” LAN cable.
• Touching the LAN terminal with a statically charged hand (body) may cause damage due
to its discharge.
Do not touch the LAN terminal or a metal part of the LAN cable.
• For instructions on how to connect, consult your network administrator.
COMPUTER
Display (main unit, rear)
Securing the LAN cable (TH-85VX200U)
Clamper
Note: In accordance with the Installation Instructions, secure the LAN cable so that it will not become near the
display unit.
When using a pedestal (TY-ST85P12) for the installation of the display, use a clamper supplied
with the display to secure the LAN cable. For use with another method of installation, refer to
the corresponding Installation Instructions.
58