Filter
Top Products
26
Troubleshooting for 3D Eyewear
Table of images that can be seen for each 3D Picture
Format and the source image format
Symptoms Checks
Cannot see 3D images • Has the 3D Eyewear been switched On?
• Ensure that “3D EYEWEAR” in “3D SETTINGS” is set to “ON”. (see
page 47)
• Some 3D image signals may not be automatically recognized as 3D
images. Set “3D INPUT FORMAT” in “3D SETTINGS” to match the
picture format. (see page 47)
• Check that there are no obstacles between the infrared sensors on
the display and the 3D Eyewear. If the 3D Eyewear stops receiving the
infrared signal for about 5 minutes, the 3D Eyewear will be turned off
automatically.
• Check the available area to use the 3D Eyewear. (see page 25)
• Depending on the person, the 3D images may be diffi cult to see, or
cannot be seen, especially in users that have a different level of eyesight
between the left and right eyes.
Take the necessary steps (wearing glasses etc.) to correct your eyesight
before use.
3D Eyewear is turned off automatically • Check that there are no obstacles between the infrared sensors on the
display and the 3D Eyewear or that the 3D Eyewear is placed inside
the coverage area (see page 25). If the 3D Eyewear stops receiving the
infrared signal for about 5 minutes, the 3D Eyewear will be turned off
automatically.
There is something wrong with the 3D
images
• Check the setting of “LEFT/RIGHT SWAP”. (see page 47)
The indicator lamp does not light when
pressing the power button on the 3D
Eyewear
• The battery may be running low or fl at. Replace it.
• If the indicator lamp does not light after the power button has been
pressed for more than 1 second, the battery may be running low or fl at.
Replace it.
If the picture appears to be abnormal, refer to the table below to choose the correct 3D picture format setting.
3D INPUT FORMAT
Source image
format
AUTO SIDE BY SIDE
TOP AND
BOTTOM
NATIVE
Side by side
*
1
Normal
*
2
Top and bottom
*
1
Normal
*
2
Normal format
(2D)
Normal
Normal
*1
When the source image is not recognized correctly
*2
When “3D EYEWEAR” is set to “ON”, the images will be displayed with 3D effect. When set to “OFF”, displayed
without 3D effect.
• Depending on the player or contents, the image may be different from the above illustrations.
Viewing 3D images