Filter
Top Products
19
Selecting the input signal
Press to select the input signal to be played back from the equipment
which has been connected to the Plasma Display.
HDMI input terminals in HDMI 1 to HDMI 4.
Component or RGB input terminal in COMPONENT/RGB IN.*
PC input terminal in PC IN.
* “COMPONENT” may be displayed as “RGB” depending on the
setting of “COMPONENT/RGB-IN SELECT”. (see page 44)
Input terminal in Terminal Board
When a dual input Terminal Board is installed, “SLOT INPUT A” and “SLOT INPUT B” are
displayed.
When an optional Terminal Board is installed:
Using dedicated buttons for input selection
Notes:
• Selecting is also possible by pressing the INPUT button on the unit.
• Select to match the signals from the source connected to the component/
RGB input terminals. (see page 44)
• Image retention (image lag) may occur on the plasma display panel
when a still picture is kept on the panel for an extended period. The
function that darkens the screen slightly is activated to prevent image
retention (see page 63), but this function is not the perfect solution to
image retention.
INPUT
MENU
ENTER/
HDMI1
HDMI2
HDMI3
HDMI4
COMPONENT
PC
INPUT
SLOT INPUT
HDMI1
HDMI2
HDMI3
HDMI4
COMPONENT
PC
INPUT
Press to select HDMI signal terminals in HDMI 1 to HDMI 4.
Press to select component or RGB signal terminal in COMPONENT/RGB IN.
Press to select PC signal terminal in PC IN.
Press to select Input terminal in Terminal Board.
For dual input Terminal Board, you can select either input terminal
using A or B button.