Filter
Top Products
8
Designation
■ Rear View
16
16
15
15
14
14
13
13
12
12
11
11
10
10
9
9
8
8
7
7
6
6
5
5
4
4
3 2
23
1
1
SIGNAL GND
10/100
BASE-T
SPOT
OUT
IN EXT STORAGE COPY
CONTROL ALARM
VIDEO
MODE
DATA
REMOTE(WV-CU50)
GEN-LOCK OUT
SERIAL
POWER
ON
AC
IN
OFF
IN
OUT
OUT
MULTI SCREEN OUT
AUDIO
$1
^0
$2
%9
$3 $4 $5 $6 $7 $8 $9 %0%1 %2%3 %4 %5 %6
%7
%8
$1 Multiscreen Output Connector (MULTISCREEN OUT)
The video output signal for the Multiscreen Monitor is
provided via this connector.
It can be displayed as the video input in a multiscreen
mode (4, 7, 9, 10, 13,16 screen segments).
It also displays the Recorder’s playback images.
Pressing the SETUP/ESC button for two seconds or
more will automatically select the Multiscreen Monitor
and display the Disk Recorder’s Setup menu.
$22 Spot Output Connector (SPOT OUT)
The video output signal for the Spot Monitor is provided
via this connector.
Displaying the Disk Recorder’s playback is disabled.
$3 Audio Input Connector (AUDIO IN)
For audio input from an external device, if applicable.
$4 Audio Output Connector (AUDIO OUT)
For audio output to an external device, if applicable.
$5 Extension Storage Port (EXT STORAGE)
For connecting the optional Extension Unit.
$6 Control Port (CONTROL)
The port has the functions listed below. Make connec-
tions to these pins as needed for operating your sys-
tem.
Pin
No.
1
2
3
4
5
6
7
8
9
10
11
12
13
Group Recording Output
Manual Recording Output
Emergency Recording
Output
Sequence Timing Output
DVD Remain Space
Output
HDD Remain Space
Output
Thermal Error Input
(Extension 1)
Thermal Error Input
(Extension 2)
Thermal Error Input
(Extension 3)
Thermal Error Input
(Extension 4)
Thermal Error Input
(Extension 5)
Thermal Error Input
(Extension 6)
Thermal Error Input (DVD
Unit)
Pin
No.
14
15
16
17
18
19
20
21
22
23
24
25
Designation
Disk Recorder Error
Output
Ground
Ground
Power Failure Detect Input
Power Failure Proceeding
Output
Power Failure Process
Completion Output
Ground
Emergency Recording
Input
Time Adjustment Output
Daylight Savings Select
Time Adjustment Input
Ground
CONTROL
1
13
14
25
@9 Direction Buttons (CDA B)
These buttons are used to select an area for a zoomed
image displayed on the Multiscreen Monitor.
During the setup, these buttons are used to move the
cursor position in the setup menu of the Disk Recorder.
C: Downward
D: Upward
A: Left
B: Right
#0 Full Indicator (FULL)
Lights to indicate when the available recording space
of the Disk Recorder (HDD) is running low.
#1 Hard Disk Drive Indicator (HDD)
Lights to indicate when the Hard Disk is activated.
The pin assignment of the port is shown below.