Filter
Top Products
– 23 –
DISC INFORMATION
The following functions can be used for a disc you have recorded
on.
About DISC INFORMATION
• You can give discs titles – Enter Title
• You can write-protect and write-enable DVD-RAM – Disc
Protection
• You can erase all programs and play lists on DVD-RAM –
Erase all programs
• You can format DVD-RAM – Format
• You can finalize DVD-R so they can be played on compatible
DVD players – Finalize
DVD-RRAM
(4) Use [ ] to select “Yes” and press [ENTER].
(4) Enter the title.
Notes:
• You can give DVD-RAM titles of up to 64 characters and DVD-R
titles of up to 40 characters.
• The 31st letter or later on some finalized DVD-R may not be
displayed due to the font size of titles.
• You cannot give DVD-R titles once they have been finalized.
• For details on entering titles, see page 32.
To stop partway through
Select “No” in step (4) and press [ENTER] or [RETURN].
To stop partway through
Select “No” in step (4) or “Cancel” in step (5) and press
[ENTER] or [RETURN].
Notes:
• The disc title will also be erased.
• If protection is active on even one program, you cannot erase all
programs.
For your reference:
• You cannot erase computer data.
• Nothing will be erased if the disc is write-protected.
All programs and play lists are erased.
Each disc can be given a different title.
(1) While stopped, press [MENU (SHIFT + SEARCH)].
(2) Use [ , , , ] to
select “DISC
INFORMATION” and press
[ENTER].
(3) Use [ , ] to select “Enter Title” and press
[ENTER].
DVD-RRAM
Enter Title
This allows you to protect discs from accidental erasure.
This allows you to release disc protection.
After performing steps (1) to (2) of “Enter Title”,
perform the following steps:
(3) Use [ , ] to select “Disc Protection” and
press [ENTER].
RAM
Disc Protection/Releasing disc protection
RAM
Erase all programs
All programs and play lists created from them will be
erased irretrievably when you use this procedure.
After performing steps (1) to (2) of “Enter Title”,
perform the following steps:
(3) Use [ , ] to select “Erase all programs” and
press [ENTER].
(4) Use [ ] to select “Yes” and press [ENTER].
(5) Use [ ] to select “Start” and press [ENTER].