Filter
Top Products
RS-232C (Female)
PAUSE REMOTE
– 42 –
Troubleshooting guide (continued)
Remote control
The remote control doesn’t work. • Check the connections between the unit and the remote control equipment.
• Close menu screens if they are open.
• [PAUSE REMOTE]: Check the control method and select the correct setting in “MODE” in
the SETUP menus.
• [RS-232C]: Check the parameters (e.g., baud rate) and select the correct settings in
“Remote” in the SETUP menus. Use the cable suitable for this unit and the
control equipment, either straight or cross.
• [USB]: Check that the USB driver is installed on the control computer.
Discs make sounds as they rotate. This does not indicate a malfunction.
Connector signals
Regarding copyright
Pin No.
1
2
3
4
5
Signal name
N.C.
TXD
RXD
N.C.
SG
Signal name
DSR
RTS ( Shorted to 8 )
CTS ( Shorted to 7 )
N.C.
Pin No.
6
7
8
9
15
69
Pin No.
1
2
Signal name
GND
PAUSE STATUS
Signal name
PAUSE CONTROL
Pin No.
3
Apparatus Claims of U.S. Patent Nos. 4,631,603, 4,577,216, and 4,819,098, licensed for limited viewing uses only.
This product incorporates copyright protection technology that is protected by method claims of certain U.S. patents and other intellectual
property rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be
authorized by Macrovision Corporation, and is intended for home and other limited viewing uses only unless otherwise authorized by
Macrovision Corporation. Reverse engineering or disassembly is prohibited.