Filter
Top Products
RAM
Erasing parts of a program (Partial Erase)
You can divide a selected program into two.
RAM
Dividing programs (Divide)
– 27 –
Using the SEARCH PROGRAM (continued)
To stop partway through
Select “Cancel” in step (8) and press [ENTER] or [RETURN].
To erase another part of the same program
Select “Next” in step (7) and perform step (8), then repeat steps
(5)–(8).
For your reference:
• Use search and slow-motion to find the points.
• You cannot specify an end point before a start point or a start
point after an end point.
• You may not be able to specify start and end points within 3
seconds of each other.
•
You cannot specify start and end points if the picture recorded is stilled.
(6) Use search functions such as fast-forward and
slow-motion to find the end point of the part you
want to erase and press [ENTER].
(6) Use [ , ] to select “Exit” and press [ENTER].
(7) Use [ ] to select “Divide” and press [ENTER].
• The program is divided at the point.
(7) Use [ , ] to select “Exit” and press [ENTER].
(8) Use [ ] to select “Erase” and press [ENTER].
• Play lists created with the erased part are also erased.
To stop partway through
Select “Cancel” in step (7) and press [ENTER] or [RETURN].
To change the point to divide
Select “Divide” in step (6), then repeat steps (5)–(7).
To check the division point
By selecting “Preview” in step (6) and pressing [ENTER], play
will begin from a point 10 seconds prior to the division point. You
may wish to make sure that the division point is at an
appropriate location.
Notes:
• The divided programs retain the title of the original program.
• A minute portion of the recording directly preceding the division
point may be lost.
For your reference:
• Use search and slow-motion to find the points.
• It is not possible to carry out “Divide” in the following cases:
• When the resulting part(s) are extremely short.
• When the total number of programs is more than 99.
• You cannot use the [STOP ] button while finding the division
point.
• The unit pauses play when the end of the program is reached
during this procedure.
• The disc’s available recording time may not increase after
erasing short parts of programs.
• You cannot use the [STOP ] button while finding start and end
points.
The specified parts of the program are erased completely
when you use this procedure and cannot be retrieved.
Check the program carefully to ensure it isn’t one you
want to keep.
You must be sure you wish to divide a program because
once a program has been divided it cannot be returned to
its original form.
After performing steps (1) to (3) of “Erasing
programs”, perform the following steps:
(4) Use [ , ] to select “Partial Erase” and press
[ENTER].
(5) Use search functions such as fast-forward and
slow-motion to find the start point of the part you
want to erase and press [ENTER].
After performing steps (1) to (3) of “Erasing
programs”, perform the following steps:
(4) Use [ , ] to select “Divide” and press
[ENTER].
(5) Use search functions such as fast-forward and
slow-motion to find the point you want to divide
and press [ENTER].