Filter
Top Products
10
Operating the TV
≥Turn on the TV.
(1) TV Power button (Í)
≥Press to switch the TV from on to standby mode or vice versa.
On some TVs with this button, it is only possible to turn it to standby mode (OFF). It is not possible
to turn it on. In this case, try to turn the TV on with the following button:
[CHJI] (4)
(2) TV Input Mode Selector (AV)
≥To select desired AV input on the TV.
(3) TV Volume up/down buttons (VOLUME s N r)
≥To adjust the volume of the TV.
(4) TV Channel up/down buttons (CHJI)
≥To select the desired programme position (TV station) on the TV.
You can operate the TVs of the manufacturers listed below with the remote control after setting it.
.............................................................................................................................................................................................................................................................................................................................
[1] Refer to the chart below for the code of your TV.
.............................................................................................................................................................................................................................................................................................................................
[2] Aim the remote control at the TV and
While holding down [Í] (1), use the numeric buttons to enter
the two-digit code.
Example: “1”; [0]l[1]
.............................................................................................................................................................................................................................................................................................................................
[3] Check whether the TV can be operated properly.
≥Test by turning on the TV and changing channels. Repeat the procedure until you find the code that
allows correct operation.
≥When a manufacturer has multiple codes in the following chart, try entering other codes if the TV
operations cannot be performed properly, and then select the optimal code.
Notes:
≥If you are using a Panasonic TV, this setting has already been made, you do not need to perform the
above procedure. However, this remote control may not work on some Panasonic TVs.
≥Some TV models cannot be operated by this remote control (including all TVs non-remote compatible).
TV OPERATION
TV Maker Setting
Brand Code
Panasonic/National 01-04
SONY 05
TOSHIBA 06
JVC 07
HITACHI 08
MITSUBISHI 09, 10
SHARP 11
PHILIPS, SAMSUNG 12
NEC 13
SANYO 14
GOLDSTAR/LG 15, 16
SAMSUNG 17, 18
SANYO 19
SLOW/
SEARCH
REW
FF
VHS/DVD
VHS
INDEX/SKIP
PLAY
TRACKING/V-LOCK
JET REW
CH
AV
VOLUME
DVD
PLAY LISTDIRECT NAVIGATOR
TOP MENU
RETURN
DISPLAY
PLAY MODE
REC MODE
VHS/DVD
CANCEL/RESET
QUICK REPLAY
AUDIO
REC
ENTERENTER
PLAY SPEED
P.MEMORY
SLOW
-/-
-
MENU
AV ENHANCER
PROG/CHECK
SET UP
I-TIMER
TIMER
DVD-RAM
DUBBING
PROG PLAY
INPUT SELECT VHS STATUS
DVD STATUSPICTURE MODEGROUP
NAVI
(1)
(3)
(4)
(2)
Numeric
buttons
VP32GCS.book 10 ページ ２００４年６月１１日 金曜日 午後４時３６分