Filter
Top Products
62
Changing the unit’s settings (continued)
Entering a password (Ratings)
You can limit play of DVDs unsuitable for some audiences,
children, for example. Play and changes to the settings are not
possible unless you enter a password.
When setting ratings
The password screen is shown when you select levels 0 to 7.
1) Input a 4-digit password with the numeric buttons (4).
≥If you enter a wrong number, press [2] (10) to erase it
before you press [ENTER] (10).
≥Do not forget your password.
2) Press [ENTER] (10).
3) Press [ENTER] (10).
The password is entered and the unit is locked.
Now, when you insert a DVD-Video that exceeds the ratings limit
you set, a message appears on the television.
Follow the on-screen instructions.
When changing ratings
The password screen is shown when you select “Ratings”.
1) Input a 4-digit password with the numeric buttons (4) and
press [ENTER] (10).
Unlock Recorder: To unlock the unit and return the rating
to 8
Change Password: To change your password
Change Level: To change the rating level
Temporary Unlock: To temporarily unlock the unit (the unit
locks again if you switch it to standby
or open the disc tray)
2) Select the item with [3, 4] (10) and press [ENTER] (10).
Actual screens depend on the operation. Follow the on-screen
instructions.
Digital output
Change these settings when you have connected equipment
through this unit’s OPTICAL DIGITAL AUDIO OUT terminal.
PCM Down Conversion
Off (Factory preset):
When you have used audio cables to connect the unit to other
equipment (analog connection [B] page 55).
On:
When you have used an optical digital cable to connect the unit to
other equipment (digital connection [A] page 55). Output is limited
to 48 kHz/16 bit.
Output of audio with a sampling frequency of 96 kHz
Audio is output as follows in accordance with the connections and
settings you make.
*
1
Audio is output at 96 kHz if the DVD is unprotected, but the
connected equipment must be able to handle such signals in
order to play them.
Dolby Digital
Bitstream (Factory preset):
When you have connected a unit with a built-in Dolby Digital
decoder.
PCM:
When you have connected a unit that doesn’t have a built-in Dolby
Digital decoder.*
2
DTS
Off (Factory preset):
When you have connected a unit that doesn’t have a built-in DTS
decoder.*
2
Bitstream:
When you have connected a unit with a built-in DTS decoder.
MPEG
Bitstream:
When you have connected a unit with a built-in MPEG decoder.
PCM (Factory preset):
When you have connected a unit that doesn’t have a built-in
MPEG decoder.*
2
*
2
Set “Dolby Digital” to “PCM”, “DTS” to “Off” and “MPEG” to
“PCM” if the other equipment doesn’t have decoders. Incorrect
settings can cause noise to be output which can be harmful to
your ears and speakers, and audio will not be recorded properly
to digital recording equipment.
Setting
Connection
[A] (digital) [B] (analog)
Off No output*
1
Output as 96 kHz
On Converted and output
as 48 kHz/16 bit
Converted and output
as 48 kHz