Filter
Top Products
Pelco Manual C1927M (5/99) 17
OPERATION FRONT PANEL COMMAND
Call a camera to the main Press any CAMERA button.
monitor.
Call a camera to the spot Press any CAMERA button twice.
monitor.
Set main tracking 1. Go to the Advanced System Setup menu.
2. Press the arrow buttons so the cursor highlights
SPOT MONITOR DISPLAY.
3. Press the +/- button until TRACK MAIN is dis-
played.
4. Exit the Advanced System Setup menu.
Call a group of cameras. 1. Make sure the RECORD LED on the left of the
front panel is OFF. If the light is on, press the
(Does not work in RECORD DISPLAY/RECORD button to toggle the light OFF.
mode)
2. Press the button below the 4, 9, or 16 icon.
3. Repeat pressing the button until the correct
group is displayed.
1. Press the button of the camera you want to dis-
play full size.
(Does not work in RECORD 2. Press the PIP icon button.
or VCR modes)
3. Press the button of the camera you want to
display in the insert.
4. To change the display in the insert, press
another camera button.
5. To exit, press the PIP icon button.
1. To sequence individual cameras, make sure the
monitor shows a full-screen view of any camera
(all modes). To sequence groups of cameras,
make sure the monitor shows a four- or nine-
camera display (LIVE and VCR modes only).
2. Press the SEQUENCE button.
Press the SEQUENCE button twice.
1. Select the desired multi-camera display.
2. Press and hold the multi-camera display button
to enter the multi-screen programming mode. A
(Does not work in RECORD bar will appear in the first camera location.
mode)
3. Use the arrow buttons to move the on-screen
bar to the desired camera location for sequenc-
ing, and press the sequence button to initiate
the sequencing of all active cameras.
Table C. Operation Guide
RESULT
Stops a sequence if one is in pro-
gress. Displays the camera on the
main monitor.
Displays the camera on the spot
monitor.
Spot monitor follows the camera
switching that occurs on the main
monitor in single screen mode. In
multi-screen mode, the spot
monitor switches to camera 1.
Displays the group of cameras on
the main monitor.
The full-size view appears on the
main monitor with the PIP insert.
Starts the pre-programmed
sequence of individual cameras or
groups of cameras on the main
monitor.
Starts the sequence of individual
cameras on the spot monitor.
The sequence will run until the
sequence button is pressed or until
another camera or multi-screen
display has been selected.
Run a sequence of cameras
on the main monitor.
Display a picture-in picture
(PIP) insert.
Run a sequence of cameras
on the spot monitor.
(Continued on next page)
Sequence multiple cameras in
one location of a 4-, 9-, or 16-
camera display.