Pelco C1927M Home Theater Server User Manual


 
28 Pelco Manual C1927M (5/99)
7. Turn activity boxes on or off.
To turn on all activity boxes, use the arrow buttons to choose SET ALL. Press the +/-
button. All boxes will contain a symbol as shown in Figure 16. The multiplexer will
monitor motion in those boxes.
To turn off all activity boxes, use the arrow keys to choose CLEAR ALL. Press the +/-
button. All boxes will be blank.
To turn on or off an individual box, use the arrow keys to select the box. Press +/-
button to toggle a box on or off.
Turn off activity boxes where you want motion ignored, such as blowing trees,
highways, computer monitors, fluorescent lighting, and non-problem areas. An
example of a non-problem area would be a camera focused on a bank vault entrance
but ignoring tellers working nearby.
8. To test the activity detection, highlight TEST and press the +/- button.
Create motion in front of the camera. Small black and white dashes will flash where
motion is detected.
To exit the test mode, press the +/- key to return to the mask.
9. If you did not like what you saw in the test mode, change the mask and test the activity
detection again.
10. When you finish defining the activity mask, go to EXIT. Press the +/- button to exit the
programming mode.
11. If necessary, repeat steps 1-10 to program the activity mask for other cameras.
SEQUENCE SETUP (SEQUENCE BUTTON)
Sequencing can be programmed in full screen, four-camera and nine-camera displays. The
cameras will not sequence when operating the zoom function. The LED(s) above the
camera button(s) will illuminate to indicate which camera(s) is being displayed.
To program camera sequencing:
1. Press the SEQUENCE button for approximately three seconds. Type the password, if
requested. The Sequence menu appears.
2. The currently selected menu item blinks.
3. Use the arrow buttons to move between items on the screen.
4. When the menu item you desire is highlighted (blinking), press the +/- button to cycle
through the options to select the one you want.
5. When you have completed all the changes you want to make, go to EXIT.
6. Press the +/- button to exit the programming mode.
When HELP is highlighted, you may press the +/- button to display a help screen that will
tell you which buttons to press to configure specific options.