Filter
Top Products
Pelco Manual C1927M (5/99) 21
NO CHANGE - This is a pass-through selection in case you unintentionally hit the +/-
button. This is not an undo button.
Alarm Inputs
Refer to the
Alarms
section for an explanation of normally closed and normally open
operation.
Dwell Rates
Sets the sequence dwell rate for all cameras. To set individual dwell rates for cameras,
refer to the
Sequence Setup
section.
Activity Detection
ENABLED/DISABLED - Turns activity detection on or off for all video inputs. To set
individual inputs, refer to the
Camera Setup
section.
NO CHANGE - This is a pass-through selection in case you unintentionally hit the +/-
button. This is not an undo button.
5. When you have completed all the changes you want to make, go to EXIT or AD-
VANCED SETUP.
6. Press the +/- button to exit the programming mode or to go to the advanced system
setup menu.
When HELP is highlighted, you may press the +/- button to display a help screen that will
tell you which buttons to press to configure specific options.
ADVANCED SYSTEM SETUP (VIEW BUTTON)
To program the advanced main system parameters:
1. Press the VIEW button for approximately three seconds. The basic System Setup
menu appears.
2. The currently selected menu item blinks. Use the arrow buttons to highlight AD-
VANCED SETUP.
3. Press the +/- button.
4. The Advanced System Setup menu appears.
5. Use the arrow buttons to move between items on the screen.
6. When the menu item you desire is highlighted (blinking), press the +/- button to cycle
through the options.
Figure 12. Advanced System Setup Menu
ALL COLOR
COLOR & B/W
RESERVED
DATE FORMAT MM-DD-YY
PASSWORD DISABLED
FRONT PANEL CONTROL ENABLED
MAIN MONITOR DISPLAY
RESPONDS TO NONE
SPOT MONITOR DISPLAY SEQUENCE
RESPONDS TO ALARMS
CAMERA TYPES ALL COLOR
UNIT ID 001
COMM. TYPE MASTER (KBD-T/D)
RELAY OUTPUT ALARM
MASTER (KBD-T/D)
SLAVE
001–240
BLANK
SEQUENCE
TRACK MAIN